34 lines
1020 B
Plaintext
34 lines
1020 B
Plaintext
AST RESEARCH TECHNICAL BULLETIN TB-0251 12/18/86
|
||
|
||
|
||
|
||
SPERRY IT AND DESQVIEW
|
||
|
||
|
||
To make the Sperry DESQview/EEMS compatible, the following
|
||
steps need to be executed:
|
||
|
||
1. Set the IT motherboard for the "B" option (switches 3 &
|
||
5 on).
|
||
|
||
2. Then set the AST EEMS board to start at 256K (SW2 -
|
||
everything on except for SW #6) and use 384K to
|
||
backfill.*
|
||
|
||
3. Run "IT-SETUP", out of Diagnostics, and select option
|
||
"1". The two choices are "0" or "1" and, in this case,
|
||
use option "1".
|
||
|
||
4. Next, set "expansion" to "0.5" (not .5, but 0.5).
|
||
|
||
5. Install REMM.SYS from SuperPak 6.10 (or later) in the
|
||
CONFIG.SYS file, and DESQview 1.11 should run.
|
||
|
||
For further information, the customer should refer to page
|
||
three of Chapter seven of the "IT" User Manual.
|
||
|
||
|
||
*The 384K being sacrificed for DESQview from the motherboard
|
||
must remain physically installed on the motherboard. Empty
|
||
sockets will cause parity errors.
|
||
|