34 lines
1020 B
Plaintext
34 lines
1020 B
Plaintext
|
AST RESEARCH TECHNICAL BULLETIN TB-0251 12/18/86
|
|||
|
|
|
|||
|
|
|
|||
|
|
|
|||
|
|
SPERRY IT AND DESQVIEW
|
|||
|
|
|
|||
|
|
|
|||
|
|
To make the Sperry DESQview/EEMS compatible, the following
|
|||
|
|
steps need to be executed:
|
|||
|
|
|
|||
|
|
1. Set the IT motherboard for the "B" option (switches 3 &
|
|||
|
|
5 on).
|
|||
|
|
|
|||
|
|
2. Then set the AST EEMS board to start at 256K (SW2 -
|
|||
|
|
everything on except for SW #6) and use 384K to
|
|||
|
|
backfill.*
|
|||
|
|
|
|||
|
|
3. Run "IT-SETUP", out of Diagnostics, and select option
|
|||
|
|
"1". The two choices are "0" or "1" and, in this case,
|
|||
|
|
use option "1".
|
|||
|
|
|
|||
|
|
4. Next, set "expansion" to "0.5" (not .5, but 0.5).
|
|||
|
|
|
|||
|
|
5. Install REMM.SYS from SuperPak 6.10 (or later) in the
|
|||
|
|
CONFIG.SYS file, and DESQview 1.11 should run.
|
|||
|
|
|
|||
|
|
For further information, the customer should refer to page
|
|||
|
|
three of Chapter seven of the "IT" User Manual.
|
|||
|
|
|
|||
|
|
|
|||
|
|
*The 384K being sacrificed for DESQview from the motherboard
|
|||
|
|
must remain physically installed on the motherboard. Empty
|
|||
|
|
sockets will cause parity errors.
|
|||
|
|
|