51 lines
2.0 KiB
Plaintext
51 lines
2.0 KiB
Plaintext
(*)*(*)*(*)*(*)*(*)
|
|
(*) (*)
|
|
(*) Crimson Box (*)
|
|
(*) Plans (*)
|
|
(*) (*)
|
|
(*)*(*)*(*)*(*)*(*)
|
|
|
|
|
|
The Crimson Box is very simple device that will allow you to put someone
|
|
on hold or make your fone busy with a large amount of ease. You flip a switch
|
|
and the person can't hear you talking. Flip it back and everything is peachy.
|
|
|
|
MATERIALS: >-:->> 100 ohm or less resistor
|
|
>-:->> SPDT toggle switch, On-Off
|
|
>-:->> Solder and soldering iron
|
|
>-:->> 3 feet of good wire
|
|
>-:->> Wire cutters
|
|
|
|
CONSTRUCTION & SCHEMATIC
|
|
|
|
First I will give you the schematic and then I will explain what the hell
|
|
is going on.
|
|
|
|
-----------black wire on line---------
|
|
--------+ red wire on line +------
|
|
--------:--+/\/\/-green wire---:------
|
|
--------:--:-yellow wire-------:------
|
|
: : :
|
|
+--:------+ :
|
|
+----+ : +----------+
|
|
: : :
|
|
1 2 3
|
|
|
|
Ok. The '/\/\/' is the resistor. And '1 2 3' is the switch where the
|
|
numbers are the poles on the switch. Notice you leave the black and yellow
|
|
wires alone. You DO NOT cut them!
|
|
|
|
Strip the red and green wires so you've got about an inch of bare wire.
|
|
Solder some of the extra wire and follow the schematic. You should have the
|
|
resistor on the green wire with an extra piece of wire coming from one leg of
|
|
it. The other leg goes to the other end of the green wire. You should solder
|
|
the green wire to the left pole of the switch and the red to the middle and
|
|
the other end of the red to the right pole.
|
|
|
|
Now, lift up the fone. If all you get is an annoying buzz then throw the
|
|
switch and you should get a dial tone. If not, don't worry and just follow
|
|
the instructions and schematic again.
|
|
|
|
This has been an HMH presentation-1985
|
|
Written and created by: Dr. D-Code
|