52 lines
2.1 KiB
Plaintext
52 lines
2.1 KiB
Plaintext
|
||
(*)*(*)*(*)*(*)*(*)
|
||
(*) (*)
|
||
(*) Crimson Box (*)
|
||
(*) Plans (*)
|
||
(*) (*)
|
||
(*)*(*)*(*)*(*)*(*)
|
||
|
||
|
||
The Crimson Box is very simple device that will allow you to put someone
|
||
on hold or make your fone busy with a large amount of ease. You flip a switch
|
||
and the person can't hear you talking. Flip it back and everything is peachy.
|
||
|
||
MATERIALS: >-:->> 100 ohm or less resistor
|
||
>-:->> SPDT toggle switch, On-Off
|
||
>-:->> Solder and soldering iron
|
||
>-:->> 3 feet of good wire
|
||
>-:->> Wire cutters
|
||
|
||
CONSTRUCTION & SCHEMATIC
|
||
|
||
First I will give you the schematic and then I will explain what the hell
|
||
is going on.
|
||
|
||
-----------black wire on line---------
|
||
--------+ red wire on line +------
|
||
--------:--+/\/\/-green wire---:------
|
||
--------:--:-yellow wire-------:------
|
||
: : :
|
||
+--:------+ :
|
||
+----+ : +----------+
|
||
: : :
|
||
1 2 3
|
||
|
||
Ok. The '/\/\/' is the resistor. And '1 2 3' is the switch where the
|
||
numbers are the poles on the switch. Notice you leave the black and yellow
|
||
wires alone. You DO NOT cut them!
|
||
|
||
Strip the red and green wires so you've got about an inch of bare wire.
|
||
Solder some of the extra wire and follow the schematic. You should have the
|
||
resistor on the green wire with an extra piece of wire coming from one leg of
|
||
it. The other leg goes to the other end of the green wire. You should solder
|
||
the green wire to the left pole of the switch and the red to the middle and
|
||
the other end of the red to the right pole.
|
||
|
||
Now, lift up the fone. If all you get is an annoying buzz then throw the
|
||
switch and you should get a dial tone. If not, don't worry and just follow
|
||
the instructions and schematic again.
|
||
|
||
This has been an HMH presentation-1985
|
||
Written and created by: Dr. D-Code
|
||
|