91 lines
4.9 KiB
Plaintext
91 lines
4.9 KiB
Plaintext
**Chrome Box Plans**
|
||
|
||
Emergency vehicles in many cities are now using devices called OptoComs.
|
||
OptoComs are a system of sensors on traffic lights that detect a pattern of
|
||
flashes from vehicle-mounted strobe lights. This flash pattern varies from
|
||
city to city depending on the manufacturer of the equipment used. Often the
|
||
sensors are installed only at major intersections. Nevertheless, the Chrome
|
||
Box, which simulates these strobe patterns can often be used to give your
|
||
car the same priority as an ambulance, paramedic van, firetruck or police
|
||
car. Because of the varying patterns on different systems this phile will
|
||
outline a general procedure for making the Chrome Box.
|
||
|
||
Decoding Flash Patterns:
|
||
|
||
First, you need to observe an emergency vehicle in action. You can wait
|
||
until you encounter one by chance, running out to see when you hear a siren,
|
||
or when you pull over in your car to let one pass by. You might wait near a
|
||
fire station for the next emergency to occur. Or, if you are very impatient,
|
||
you can summon one by calling in a false alarm (not recommended in areas
|
||
with limited services that could divert attention from a real emergency).
|
||
If the OptoComs in your area are the kind with a pattern of single flashes
|
||
at a steady rhythm, you have merely to buy a strobe light at Radio Shack &
|
||
adjust the flash rate until you can induce a traffic light to change.
|
||
|
||
If the flash pattern is more complex, you can videotape the emergency
|
||
vehicle & then play back the tape in single-frame mode, counting the number
|
||
of frames between each flash. Each video frame is 1/30 of a second, using
|
||
this you can calculate the time between flashes in the pattern. Another way
|
||
is to count the number of flashes (or flash-groups) in one minute and use
|
||
that to compute the rate. Counting video frames will give you a good idea of
|
||
the spacing of the flashes in a complex pattern. For really accurate
|
||
information, call the fire station & ask them, or write to the manufacturer
|
||
for a service manual, which will include a schematic diagram that you can
|
||
use to build one. A good cover story for this is that you are a consultant
|
||
& one of your clients asked you to evaluate Optocom systems, or you could
|
||
pose as a free-lance journalist writing an article.
|
||
|
||
Modifying the Strobe Light:
|
||
|
||
You may not have to modify the strobe at all. But if you need a faster
|
||
flash rate than your strobe allows, open it up & find the large capacitor
|
||
inside. Capacitors are marked in microfarads, abbreviated as mf,mfd or ufd.
|
||
By replacing the capacitor with one of the same voltage-rating (usually 250
|
||
volts or more) and a SMALLER value in microfarads, you can increase the
|
||
flash rate. Halving the microfarads doubles the rate.
|
||
The other component that can be changed is the potentiometer (the speed
|
||
control device with the knob on it). Using a smaller value (measured in ohms
|
||
or Kilohms, abbrevaited with the greek letter 'omega' or the letter K) will
|
||
speed up the strobe. There may also be a resistor (small cylinder with
|
||
several colored stripes on it, and wires coming out of each end). Replacing
|
||
this resistor with one of smaller value will also speed up the strobe.
|
||
To generate a complex pattern, you will either have to design and build a
|
||
triggering circuit using IC chips, or rig up a mechanical device with a
|
||
multiple-contact rotary switch and a motor. It HAS been done.
|
||
|
||
To modify the strobe for mobile operation the simplest thing is to get a
|
||
110-volt inverter that will run off of a car battery by plugging into the
|
||
cigarette lighter & run the strobe from that. Or, you can figure out
|
||
(or find in a hobby electronics magazine) a strobe circuit that will run
|
||
from batteries. Battery-powered strobes may also be availble, either
|
||
assembled or as kits.
|
||
|
||
Stealth Technology:
|
||
|
||
Most light sensors and photocells are more sensitive in the infrared area
|
||
of the light spectrum. Infrared (IR) is invisible to the human eye. Putting
|
||
an infrared filter over the strobe light may allow the Chrome Box to
|
||
operate in traffic undetected by police or other observers. IR filters can
|
||
be obtained from military surplus sniperscope illuminators, or from optical
|
||
supply houses like Dow-Corning or Edmunds Scientific Co.
|
||
|
||
Using the Chrome Box:
|
||
|
||
Mounted on your car, the Chrome Box can guarantee you green lights at major
|
||
intersections in cities that have OptoComs. Handheld Chrome Boxes may be
|
||
used to create gridlock by interfering with the normal flow of traffic.
|
||
If you have access to a window overlooking a traffic light, you can play
|
||
pranks by switching the signals at inappropriate moments, or you can plug
|
||
the strobe into an exposed out let at a laundromat or gas station.
|
||
|
||
Soe Decoded Patterns:
|
||
|
||
Torance, California
|
||
Standard large Radio Shack strobe lights are used. Moderately fast rate.
|
||
* * * * * * * *
|
||
|
||
Manhattan Beach,CA
|
||
Flash-pairs in a 4:1 ratio, at a rate of 2 flash-pairs per second.
|
||
* * * * * * * *
|
||
<------ 1 sec ----->
|
||
|