36 lines
1.6 KiB
Plaintext
36 lines
1.6 KiB
Plaintext
Date: 2 February 1985
|
||
From: Headquarters, Indiana Wing/DC
|
||
To: Azden PCS-300 Owners
|
||
Subj: Adjustment of PCS-300 PLL
|
||
|
||
One of our members recently experienced a problem with his Azden
|
||
PCS-300 handheld VHF transceiver. The problem appeared to be a
|
||
failure to transmit for more than a second or two at the
|
||
beginning of each transmission. In actuality, the radio was
|
||
transmitting but the frequency was slowly drifting up to about
|
||
151 MHz.
|
||
|
||
After some correspondence with the U.S. distributor of the radio,
|
||
the following cure was found. The problem is caused by a
|
||
misalignment of the VCO in the PLL circuit.
|
||
|
||
There are 3 circuit boards in the PCS-300. Of course, the one
|
||
you want is the most difficult to get at, the one in the middle.
|
||
|
||
To get at the correct board, first you must remove the cover.
|
||
Then you must remove 4 screws, 2 at the bottom of the radio,
|
||
underneath the battery pack, and 2 more near the top of the radio
|
||
between the top circuit board and the heat sink. This will
|
||
enable you to separate the radio, but the plug-in cable to J101
|
||
is quite short and must remain connected for you to make the
|
||
required measurements. If you will turn the front panel
|
||
counterclockwise about 1/8 turn, you should be able to get at
|
||
transformer T104 which is quite close to R137. The top exposed
|
||
end of R137 is TP103.
|
||
|
||
1.) Turn power on and connect digital voltmeter to TP103.
|
||
2.) Set frequency of radio for 142.000 MHz.
|
||
3.) Adjust T104 until voltmeter reads 1.00 volts plus or minus
|
||
0.3 volt.
|
||
|
||
|