96 lines
3.9 KiB
Plaintext
96 lines
3.9 KiB
Plaintext
|
|
How To Use PC Pursuit Service
|
|
-----------------------------
|
|
|
|
Placing a PC Pursuit Call
|
|
-------------------------
|
|
|
|
* Use a modem to dial your local Telenet access telephone
|
|
number with parameters settings of 8-N-1.
|
|
|
|
* Type two CARRIAGE RETURNS (CR) D (CR)
|
|
|
|
|
|
Telenet Prompt User Input Comments
|
|
======================================================================
|
|
|
|
(1) Terminal = D1 (CR) Input Terminal ID.
|
|
D1 is typical for
|
|
PC's. If not known,
|
|
type CR.
|
|
|
|
(2) @ C D/NYNYO/12,YOUR ID (CR) Type area code desired,
|
|
modem speed and your
|
|
user ID. (Note that
|
|
/3 = 300 bps, /12 = 1200
|
|
bps, /24 = 2400 bps).
|
|
|
|
(3) PASSWORD = PASSWORD (CR) Enter user Password
|
|
|
|
(4) D/NYNYO/12 Connected to target
|
|
CONNECTED city outdial modem.
|
|
|
|
(5) ATZ Type ATZ (in upper case)
|
|
|
|
(6) OK Modem responds as cleared.
|
|
|
|
(7) ATDT 7654321 Type ATDT (in upper case)
|
|
and the 7-digit number
|
|
you wish to dial.
|
|
|
|
(8) CONNECT (CR) (CR) You are now connected to
|
|
the computer that you
|
|
dialed. Procees as if
|
|
the number was dialed
|
|
directly.
|
|
|
|
|
|
NOTES:
|
|
-----
|
|
|
|
1. If the connection was not made, a BUSY will be seen within 30
|
|
seconds. The BUSY message means that the number dialed was either
|
|
busy, not in service, or an invalid attempt to dial more than 7
|
|
digits. A BUSY will also be seen after disconnecting from the
|
|
host computer, but you can dial another number by starting again
|
|
at the fifth step and typing ATZ and dialing the number.
|
|
|
|
2. PC Pursuit uses standard HAYES dialing commands, which enable
|
|
you to type the A/ (no CR) command to redial the previously
|
|
dialed number.
|
|
|
|
3. When a typing mistake is made in the second and third steps,
|
|
the log-on must be re-entered.
|
|
|
|
|
|
To Disconnect from PC Pursuit
|
|
-----------------------------
|
|
|
|
Telenet Prompt User Input Comments
|
|
======================================================================
|
|
|
|
(CR) @ (CR) Escape to Telenet
|
|
command level.
|
|
|
|
@ D (CR) At the @ sign,issue
|
|
disconnect command.
|
|
|
|
D/NYNYO/12 Disconnect from the
|
|
DISCONNECTED target city complete.
|
|
User is still connected
|
|
to Telenet at the local
|
|
dial-up city. A PC Pursuit
|
|
can now be placed to
|
|
another city.
|
|
|
|
|
|
NOTES:
|
|
------
|
|
|
|
1. To DISCONNECT FROM TELENET, log off your computer as usual, or
|
|
hang-up.
|
|
|
|
|
|
|
|
Downloaded From P-80 Systems 304-744-2253
|