textfiles/games/CONSOLES/swc.txt
2021-04-15 13:31:59 -05:00

302 lines
11 KiB
Plaintext
Raw Blame History

This file contains invisible Unicode characters

This file contains invisible Unicode characters that are indistinguishable to humans but may be processed differently by a computer. If you think that this is intentional, you can safely ignore this warning. Use the Escape button to reveal them.

E.V.O.L.U.T.I.O.N. A.U.S.T.R.A.L.I.A.
o o o
/\ /\ /\ ___o ___o
o_____________/ \_ _______o / \ / \_________| |____________o | |
\ __ / / |\ \ / ./ __\ \ _ \ |\ \ \ | .|
\ \__/_/___/ ./ |/\ /\ .\/ o/ | .\ \___\) .) .|/\ /\ \ \ \| o|
/\_______// o/ / / / o/ O/___| o|\ \ / o/ o/ / / o/ .\ \ O|
/ /_/ O/ O/| ( (_/ O/ /_) ) O|_) )/ O/| ( (_/ O/ o|\ |
\ ____/_________\ \___/_________/________// / |___\_______/| O| \___|
_\ \______________\ \_____________________/ / | |______
_________________________________________________/ Poise/RaZoR PC |__________
Presents : The Super Wild Card & Super Magicom Programmers Handbook.
Typed by : MicroChip/Evolution/Submission
Call the Evolution WHQ on : Southern Cross BBS (SNES/MD/PC/AMIGA)
--> +61-3-428-9359 (2 Nodes Ringdown)
***************************************************************************
HardWare Specifcations & Features
---------------------------------
1) DRAM - 28Mega Bits Maximum Available
2) SRAM - 256k (Battery Backup)
3) ROM - 128k (Firmware)
4) Floppy Drive Interface -
* Motorola MCS3201 Chip (NEC 765A Compatible)
* Compatible with IBM PC/AT & XT Disk Drive System
* Suports 3.5" & 5.25" Flopy Disk Drive.
* DB-25 Female Connector (non-standard)
* Supports only Non-DMA mode (polling)
5) Parallel Port Interface -
* 8 bits input, 4 bits output, 1 bit handshake.
* DB-25 Female Connector
* Use Male to Male DB-25 Connector to connect to PC's Parallel Port
6) Core Chip -
* Altera EP1810 Chip (First Generation)
* Front Far East FC9203 Chip (Currently Shipping)
* Front Far East FC9304 Chip (Not Avilable)
7) Versions -
Ver. Bios-Name Core Mode21 Saver Description
'A' Magicom EP1810 No Yes External Drive
'B' Wild Card EP1810 Yes Yes External or Bulid-in DD
'C' Wild Card FC9203 Yes Yes External or Bulid-in DD
'D' Wild Card FC9304 Yes Yes (Under Development)
'E' Wild Card EP1810 Yes No Magic Drive Adapter
'F' Wild Card FC9203 Yes No Magic Drive Adapter
SoftWare Specifications & Features
----------------------------------
1) Registers -
[Floppy Drive I/O]
C000R : Input Register
Bit 7 - MCS3201 IRQ Signal
Bit 6 - Drive 'Index' Signal (Disk Insert Check)
C002W : Digital Output Register
C004R : Main Status Register
C005RW: Data Register
C007R : Digital Input Register
C007W : Disk Control Register
* Consult the MCS3201 Data Sheet for more detailed information.
[Parallel I/O]
C008R : Bit 07 : Parallel Data Input (reading this register will
reverse the busy flag)
C008W : Bit 03 : Parallel Data Output
Bit 00 : 0=Mode 20, 1=Mode 21 (DRAM Mapping)
Bit 01 : 0=Mode 1, 1=Mode 2 (SRAM Mapping)
C009R : Busy Flag, Bit 7 (EP1810 Version)
C000R : Busy Flag, Bit 5 (FC9203 Version)
[Page Select]
E000W : Memory Page 0
E001W : Memory Page 1
E002W : Memory Page 2
E003W : Memory Page 3
[Mode Select]
E004W : System Mode 0 (Bios Mode, Power On Default)
E004W : System Mode 0 (Play Cartridge)
E004W : System Mode 0 (Cartridge Emulation 1)
E004W : System Mode 0 (Cartridge Emulation 2)
[Others]
E008W : 44256 Dram Type (For 2,4,6,8 Mega Dram Card.
E009W : 441000 Dram Type (For 8,16,24,32 Mega Dram Card)
E00CW : Enable cartridge page mapping at A000FFF (Sys Mode 0)
Disable cartridge page mapping at bank 205F,A0 (Sys Mode 2,3)
E00DW : Enable SRAM page mapping at A000FFF (Sys Mode 0)
Enable cartridge mapping at Bank 205F,A0 (Sys Mode 2,3)
* The bank address of the above registers is 007D,80.
* The above registers are available only in System Mode 0 (BIOS Mode)
* [Mode Select] registers also available in System Mode 2.
2) Memory Mapping -
[System Mode 0]
bb2000B3FFFRW : SRAM or Cartridge page mapping, bb=407D,C0
bb8000B9FFFRW : DRAM page mapping, bb=007D,80
bbA000bBFFFRW : SRAM or Cartridge page mapping, bb=007D,90
bbC000W : I/O Registers, bb=007D,80 (Registers)
bbE000bFFFFR : ROM Page mapping, bb=01 (Firmware)
* 1 Page = 8k Bytes, 1 Bank = 4 pages
* bb:000F = 4 Mega Bytes
* bb:001F = 8 Mega Bytes
* bb:002F = 12 Mega Bytes
* bb:003F = 16 Mega Bytes
[System Mode 1]
bb0000b7FFFR : Cartridge Mapping, bb=407D,C0 (Mode 21)
bb8000bFFFFR : Cartridge Mapping, bb=007d,80 (Mode 20,21)
[System Mode 2]
bb0000b7FFFR : DRAM Mapping, bb=407D,C00 (Mode 21)
bb8000BFFFFR : DRAM Mapping, bb=0070,800 (Mode 20,21)
70800070FFFFRW : SRAM Mode 1 Mapping
306000307FFFRW : SRAM Mode 2 Mapping, Page 0
316000317FFFRW : SRAM Mode 2 Mapping, Page 1
326000327FFFRW : SRAM Mode 2 Mapping, Page 2
336000337FFFRW : SRAM Mode 2 Mapping, Page 3
* bbE004bE007W : Mode Select Registers, bb=007D,80
[System Mode 3]
bb0000b7FFFR : DRAM Mapping, bb=406F,C0 (Mode 21)
bb8000BFFFFR : DRAM Mapping, bb=006F,80 (Mode 20,21)
70800070FFFFRW : SRAM Mode 1 Mapping
306000307FFFRW : SRAM Mode 2 Mapping, Page 0
316000317FFFRW : SRAM Mode 2 Mapping, Page 1
326000327FFFRW : SRAM Mode 2 Mapping, Page 2
336000337FFFRW : SRAM Mode 2 Mapping, Page 3
* Mode 21 - Even DRAM is mapped to bb0000b7FFF
Odd DRAM is mapped to bb8000bFFFF
3) Parallel I/O Protocol -
[Protocol used in PC]
* Byte Output procedure:
Wait Busy Bit = 1 Status Port Bit 7 (Hex n79,n7D)
Write One Bytes Data Latch (Hex n78,n7C)
Reverse Strobe bit Control Port Bit 0 (Hex n7a,n7E)
* Byte Input procedure:
Wait Busy Bit = 0 Status Port Bit 7 (Hex n79.n7D)
Read Low 4 bits of byte Status Port Bit 36 (Hex n79.n7D)
Reverse Strobe bit Control Port Bit 0 (Hex n7A.n7E)
Wait Bust Bit = 0 Status PortBit 7 (Hex n79.n7D)
Read High 4 Bits of byte Status Port Bit 36 (Hex n79.n7D)
Reverse Strobe Bit Control Port Bit 0 (Hex n7A.n7E)
* 5 Types of Commands
* Command length = 9 bytes
* Command Format:
Byte 1 D5 ID Code 1
Byte 2 AA ID Code 2
Byte 3 96 ID Code 3
Byte 4 00|01|04|05|06 Command Code
Byte 5 A1 Low Byte of Address
Byte 6 AH High Bytes of Address
Byte 7 LL Low Byte of Data Length
Byte 8 LH High Byte of data Length
Byte 9 CC Checksum = 81^Byte4^Byte5^Byte6^Byte7^Byte8
* Command [00] : Download Data
a1,ah = Address
11,1h = Data Length
Output Data after Command
* Command [01] : Upload Data
a1,ah = Address
11,1h = Data Length
Input Data after Command
* Command [04] : Force SFC Program to JMP
a1,ah = address
* Command [05] : Set Memory Page Number
a1 Bit 1 = Page Number
a1 Bit27 + ah Bit 1 = Bank Number
* Command [06] : SUB Function
a1 = 0 Initial Device
a1 = 1 Play Game in DRAM
a1 = 2 Play Cartridge
Password Format
---------------
1) Description -
Use the Data in the password to replace the data in the memory
at the offset address (according to the game file)
2) Format 1 -
* Game Doctor Gold Finger Format
* 20 bits address space assigment
* 3 data bytes per string
* [Gaaaaaddddddccc]
'G' = Means Game Doctor Format
aaaaa = Offser address of game file (Excluding 512 bytes header)
dddddd = 3 data Bytes (If the second ot the third data is '00',
this means that the data is uncganged in
the second of third byte)
ccc = Checksum (Not used in SWC and SMC)
3) Format 2 -
* 'FFE' Format
* 24 bit address space assigment
* 1 to 36 data bytes per string
* No Checksum
* [nnaaaaaadd....]
nn = Data bytes length
aaaaaa = Offset Address of Game file (excluding 512 bytes header)
dd.... = nn Bytes data (Should be nn*2 Characters)
File Header
-----------
1) Created by JSI/Front Far East
2) 512 Bytes Length
3) Byte
0 - Low Byte of 8k-Bytes page Counts
1 - High Byte of 8k-Bytes page Counts
2 - Emulation Mode Select
Bit 7 6 5 4 3 2 1
x : 1=Run in Mode 0 (Jump $8000)
x : 0=Last File of the Game (Multi-File)
x : 0=Mode 1, 1=Mode 2 (SRAM Mapping)
x : 0=Mode 20, 1=Mode 21 (DRAM Mapping)
x : 0=Run in Mode 3, 1=Run in Mode 2 (JMP Reset)
x : 0=Disable, 1=Enable (external cartridge
memory image at Bank 205F,A0 System Mode 2,3)
8 - File ID Code 1 (Should be 'AA')
9 - File ID Code 2 (Should be 'BB')
10 - Check this byte if ID 1 & 2 Match
02 : Magic Griffin Game File (PC Engine)
03 : Magic Griffin SRAM Data File
04 : SWC & SMC Game File (SNES)
05 : SWC & SMC Password, SRAM data, Saver Data File.
06 : SMD Game File (Megadrive)
07 : SMD SRAM Data File
37 - Reserved (Should be 00)
11511 - Reserved (Should be 00)
****************************** The End ***********************************
Personal Greetings go to:
Ice/ATX - See ya at the Rave!
Krayzi/PE - Stop pulling those pipes.
Krimsym - See ya at Insanity!
VIking Child/Submission - Use a condom next time!
Ginnie/Razor - PC's RULE - NOT!
TV & Revenger/Submission - Why an A4000?
Poise/Razor - Where's my text screen??
Itec/Submission - Lets get TCC going again?
Mixer/Mel - See ya at Kentucky!
WormEater & RAM - Call my board!
Kirk/Anthrox - How ya going Pete? Will Call ya soon!
Mat - Speed kills - NOT!
Choronzon - Let me see ya trade!
Sweet Thing - Thanx for the support!
Woody & Sandman - Call my bbs you lazy bastards.. hehe
Cameo - I want a pre-release...
Rotox - Call me..
Mr. IRQ - Dove' il mio manuale?
Jacknife - Thanx for the Support Dude!
And to all my friends I have forgotten about coz I am tired!
Group Greetings go to:
Submission, Magical, Anthrox, Paradox, Razor, Fairlight, BSL, Elitendo,
PE, Quartex, Skid Row and to all others I missed!
NOTE: If any Australian's wish to purchase a Super Wild Card they are
asked to call (03) 883-0297 (24hour paging service)............