115 lines
6.4 KiB
OpenEdge ABL
115 lines
6.4 KiB
OpenEdge ABL
SEAGATE TECHNOLOGY, INC.
|
||
Customer Technical Support FAX Network +1 408 438-8137
|
||
Customer Technical Support Bulletin Boards (300-9600, 8-N-1)
|
||
ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÂÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿
|
||
³ United States +1 408 438-8771 ³ United Kingdom +44 628 478011 ³
|
||
ÃÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ´
|
||
³ Germany +49 89 140-9331 ³ Singapore +65 227-2217 ³
|
||
ÀÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÁÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÙ
|
||
(C)opyright 1993
|
||
|
||
|
||
|
||
ST-410800W Elite 9 Fast SCSI-2 Wide
|
||
|
||
ÚÄ Terminator Power Source (see below)ÄÄ¿
|
||
4o³o3 ³
|
||
J4A 2o o1 J4B ³
|
||
o o o o o o A R o o Power o o o o ³
|
||
o o o o o o g F o o ___________________ Ú12ÄGÄGÄ5Ä¿ o o o o ³
|
||
ÍØÍØÍØÍØÍØÍØÍÍØÍØÍØÍÍØÍÍÍ( ×××××××××××××××××1)ÍÍÍÍ͵ 0 0 0 0 ÆÍØÍØÍØÍØÍÍ ³
|
||
8 4 2 1 ³ ³ ÃÄÙ ³ ³ \ÄÄÄÄÄÄÄÄÄÄÄijÄÄÄÄ/ \ÄÄÄÄÄÄÄÄÄ/ ³ ³ ³ ³ ³
|
||
ÄÄÄÂÄÄÄ ³ ³ ³ ³ ³ SCSI Cable Connector 68-pin ³ ³ ³ ³ ³
|
||
³ ³ ³ ³ ³ ³ ³ ³ ³ ³ ³
|
||
³ ³ ³ ³ ³ ÀÄÄ Spindle Synch Cable Connector ³ ³ ³ ³ ³
|
||
³ ³ ³ ³ ³ (top pin: SSREF, bottom: ground) ³ ³ ³ ³ ³
|
||
³ ³ ³ ³ ÀÄÄÄÄÄ Terminator Enable ³ ³ ³ ³ ³
|
||
³ ³ ³ ÀÄÄÄÄÄÄÄÄÄ LED Connection (g: ground pin) ³ ³ ³ ³ ³
|
||
³ ³ ³ Activity (A-G) ³ ³ ³ ³ ³
|
||
³ ³ ³ Ready (R-G) ³ ³ ³ ³ ³
|
||
³ ³ ³ Fault (F-G) ³ ³ ³ ³ ³
|
||
³ ³ ÀÄ Reserved ³ ³ ³ ³ ³
|
||
³ ÀÄÄÄ Write Protect Enable Spinup Delay ÄÙ ³ ³ ³ ³
|
||
ÀÄÄÄÄÄÄÄÄ SCSI ID (10 secs * ID) ³ ³ ³ ³
|
||
Motor Start option enable ÄÄÄÙ ³ ³ ³
|
||
Parity check DISable ÄÄÄÄÄÙ ³ ³
|
||
Reserved ÄÄÄÄÄÄÄÙ ³
|
||
ÕÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ͸ ³
|
||
³ Terminator Power Source Options ÃÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÙ
|
||
ÃÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÁÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿
|
||
³ 2 & 4 Ä Initiator supplies power over the SCSI Bus for terminators. ³
|
||
³ Drive supplies no terminator power. ³
|
||
³ 1 & 2 Ä Drive supplies power for its own terminator resistor-paks ³
|
||
³ but not to SCSI Bus. This is the factory setting. ³
|
||
³ 1 & 3 ³
|
||
³ AND Ä Drive supplies power for external terminator at end of the ³
|
||
³ 2 & 4 daisy chain. Terminator resistor-paks must be removed. ³
|
||
³ This option is recommended only for last drive on daisy ³
|
||
³ chain. ³
|
||
ÀÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÙ
|
||
ST410800WD drives are shipped without terminators and have
|
||
empty terminator sockets on the PCB. You must provide
|
||
termination resistors for these drives.
|
||
|
||
|
||
ST-410800W
|
||
Elite 9
|
||
|
||
UNFORMATTED CAPACITY _____________________10,800
|
||
FORMATTED CAPACITY (512 byte blk) ________9,090
|
||
AVERAGE SECTORS PER TRACK ________________133 (rounded down)
|
||
ACTUATOR TYPE ____________________________ROTARY VOICE COIL
|
||
TRACKS ___________________________________132,975
|
||
CYLINDERS ________________________________4925
|
||
HEADS ____________________________________27
|
||
DISCS (5.25 in) __________________________14
|
||
MEDIA TYPE _______________________________THIN FILM
|
||
HEAD TYPE ________________________________THIN FILM
|
||
RECORDING METHOD _________________________ZBR RLL (1,7)
|
||
INTERNAL TRANSFER RATE (mbits/sec) _______45-66
|
||
INTERNAL TRANSFER RATE AVG (mbyte/sec) ___7.2
|
||
EXTERNAL TRANSFER RATE (mbyte/sec) _______20 (burst)
|
||
SPINDLE SPEED (RPM) ______________________5,400
|
||
AVERAGE LATENCY (mSEC) ___________________5.55
|
||
COMMAND OVERHEAD (mSEC) __________________<0.5
|
||
BUFFER ___________________________________1024 Kbyte
|
||
Read Look-Ahead, Adaptive, Multi-Segmented
|
||
Cache
|
||
INTERFACE ________________________________SCSI-2 FAST
|
||
BYTES PER TRACK __________________________63,000-91,000
|
||
SECTORS PER DRIVE ________________________17,845,731
|
||
BYTES PER CYLINDER _______________________1,058,400 to 1,587,600
|
||
TPI (TRACKS PER INCH) ____________________3,979
|
||
BPI (BITS PER INCH) ______________________
|
||
AVERAGE ACCESS (ms) read/write ___________11/12
|
||
SINGLE TRACK SEEK (ms) read/write ________0.9/1.7
|
||
MAX FULL SEEK (ms) read/write ____________23/24
|
||
MTBF (power-on hours) Class A Room _______NA
|
||
MTBF (power-on hours) Office _____________500,000
|
||
POWER DISSIPATION (watts) ________________
|
||
POWER REQUIREMENTS: Single-ended/Differential
|
||
+12V START-UP (amps) _3.98/4.60
|
||
+12V TYPICAL (amps) __1.90/1.88
|
||
+5V START-UP (amps) __2.37/3.48
|
||
+5V TYPICAL (amps) ___1.96/2.77
|
||
TYPICAL ( watts seek/read)_32.60/36.41
|
||
IDLE (watts) ______________28.34/31.81
|
||
USER MANUAL PART NUMBER __________________
|
||
OTHER ____________________________________
|
||
Synchronized Spindles, Sweep Cycle Capability
|
||
|
||
** Already low-level formatted at the factory with nine spare sectors
|
||
per cylinder, one spare cylinders/unit, one system cylinder/unit, and
|
||
one diagnostic cylinder/unit.
|
||
|
||
Physical:
|
||
Height (inches/mm): 3.25/82.6
|
||
Width (inches/mm): 5.75/146.1
|
||
Depth (inches/mm): 8.0/203
|
||
Weight (lbs/kg): 7.8/3.6
|
||
|
||
|
||
Seagate reserves the right to change, without notice, product
|
||
offerings or specifications. (03/24/94)
|
||
|