64 lines
3.4 KiB
Plaintext
64 lines
3.4 KiB
Plaintext
PrimoPyro1990
|
||
|
||
|
||
|
||
|
||
... TEARGAS AND RELATED ITEMS ...
|
||
|
||
|
||
DISCLAIMER: This file contains information on making substances which are
|
||
illegal or harmful. Neither the BBS carrying this file nor its
|
||
author can be considered responsible for making this information
|
||
available. This file is intended for information only.
|
||
|
||
|
||
|
||
CAPSTUN: Capstun (capsaicin) is the active oil in red pepper. If you don't
|
||
think something derived from pepper can be as good as CN or CS tear gas,
|
||
think. Even if a person is maced, he can still can still function if he is
|
||
motivated enough. Capstun is an irritant which causes nasal passages to swell
|
||
, making the affected person breathe through their mouth which in turn causes
|
||
them to inhale the capstun which affects the throat causing choking. It's
|
||
effect in the eyes is extreme tearing and pain. In addition it causes a
|
||
burning sensation on any exposed skin. Capstun does not cause permanent
|
||
damage.
|
||
Capstun is easy to make. The only drawback is you have to heat up ethyl
|
||
alcohol which is flammable.
|
||
Obtain 1 lb. of dried red or green hot peppers. The hotter the better. Chop
|
||
them up in a blender and put them into a large jug. Add denatured ethyl
|
||
alcohol to the peppers until they are covered by an inch or two of alcohol.
|
||
Put the jug into a pot of water on an electric burner and bring the alcohol
|
||
almost to a simmer. Be very careful as the alcohol fumes can ignite. Don't
|
||
use a flame to heat the water. Let the alcohol cool a bit then filter it off.
|
||
Repeat this 3 times. Throw out the peppers and put all the alcohol into a
|
||
large mouthed jar. Take the water pot/heater outside and heat up the alcohol.
|
||
Evaporate the alcohol down to about 100 mls. Filter off the alcohol again
|
||
and let it evaporate to leave a thick reddish oil. If you are adventurish
|
||
take a minute amount of the oil and taste it. Have plenty of water on hand
|
||
though.
|
||
Capstun is usually used as a 1% to 5% solution. Cut it down with mineral oil
|
||
or another suitable carrier.
|
||
CAPSTUN BOMB: Take a 12 gauge shotgun shell and open the crimp. Pour out the
|
||
shot and seal the shot cup with a thin layer of epoxy. The seal must be oil-
|
||
proof. Take a 1 in. long piece of broomhandle and drill a small hole through
|
||
it's center. Epoxy it onto the brass end of the shell so that the hole is
|
||
over the primer. Now fill the shell with a 5% solution of capstun. Close the
|
||
crimp up again and epoxy the end shut. Take a cloth streamer about 1 1/2 in.
|
||
wide by 2 ft. long and epoxy one end of it to the crimp end of the shell.
|
||
When all is ready take a short nail and insert it through the hole up against
|
||
the primer. Hold it in place with 2 pieces of tape. To use this, fold the
|
||
streamer up in your palm and place the shell on top of the streamer. Throw
|
||
the shell in a high arc. The streamer will cause the shell to land nail end
|
||
first setting off the primer. When the shell goes off it will spray the
|
||
capstun into the air. Two of these can clear the street.
|
||
If you have problems with the capstun leaking, try loading it first into a
|
||
small plastic bag. Heat seal the open end of the bag then load it in the
|
||
shotgun shell without the shot cup.
|
||
Even though the capstun won't cause damage, the carrier it is dissolved in
|
||
can, so chose it carefully.
|
||
|
||
|
||
|
||
*** Kilroy was here ***
|
||
|
||
|