90 lines
4.6 KiB
Plaintext
90 lines
4.6 KiB
Plaintext
How to make Nitroglycerin and How to use it.
|
||
|
||
Nitro is a very powerful high explosive. The byproducts of nitro is nothing but
|
||
nitrogen, carbon dioxide, water, and oxygen.
|
||
|
||
To make nitro.
|
||
|
||
Mix 100 parts fuming nitric acid, with specific gravity of 50 degrees
|
||
baume, with 200 parts sulphuric acid. This is going to be hot at first. It
|
||
won't splatter if you pour the nitric into the sulphuric. The acid solutions
|
||
together can dissolve flesh in a matter of seconds so take care when using
|
||
them!! When cool, add 38 parts glycerine as slowly as possible. Let it trickle
|
||
down the sides of the container into the acids or it won't mix thoroughly and
|
||
the reaction could go to fast which causes enough heat to ignite itself. If you
|
||
see the mixture turn brown or look funny, run like hell!! This means it is
|
||
about to explode! (Nitroglycerin can fill up to 10,000 times it's original area
|
||
with expanding gases. This means that if you have 10ml's somewherel it will
|
||
produce 100,000ml of gases). Stir with a GLASS rod for 15 seconds then
|
||
carefully pour it into 20 times it's volume of water. It will visibly
|
||
precipitate immediately. There will be twice as much nitro as you used glycerine
|
||
and it is easy to separate. Mix it with baking soda as soon as you have
|
||
separated it this helps it not to go off by itself.
|
||
|
||
NOTES: Parts are by weight and the baume scale of specific gravity can be found
|
||
in most chemistry books. You can get fuming nitric and sulfuric acids wherever
|
||
good chemicals or fertilizers are sold. It is positively STUPID to make more
|
||
than 200 grams of nitro at time. When mixing the stuff wear goggles, gloves,
|
||
etc. One experience of having the stuff going off by itself blew both a window
|
||
and the table it was sitting on away. This was done with only 25g of the stuff.
|
||
|
||
Once you have made the nitro and saturated it with bicarb. you can make a
|
||
really powerful explosive that won't go off by itself by simply mixing it
|
||
fieasy uch cotton as you can and them saturating that with molten wax...just enough
|
||
to make it sealed and hard. Typically, use the same amounts ( by weight ) of
|
||
each nitro, cotton and wax. This when wrapped in newspaper was once known as "
|
||
Norbin & Olson's patent dynamite " but that was back in 1896.
|
||
|
||
|
||
|
||
|
||
How to make TNT
|
||
|
||
1. Get two clean beakers. In the first, prepare a solution of 76% sulfuric
|
||
acid, 23% nitric acid and 1% water. In the other beaker prepare another
|
||
solution of 57% nitric acid and 43% sulfuric acid. Percentages are on a weight
|
||
ratio, not by volume.
|
||
|
||
2. Ten grams of the first solution are poured into an empty beaker and placed
|
||
in an ice bath.
|
||
|
||
3. Add ten grams of toluene, and stir for several minutes.
|
||
|
||
4. Remove this beaker from the ice bath and gently heat until it reaches 50
|
||
degrees C. The solution is stirred constantly while being heated.
|
||
|
||
5. Fifty additional grams of the acid from the first beaker are addedEand the
|
||
temperature is allowed to rise to 55 C. This temp is held for the next ten
|
||
minutes. an oily liquid will begin to form on the top of the acid.
|
||
|
||
6. After 10-12 minutes, the acid solution is returned to the ice bath, and
|
||
cooled to 45 C. When reaching this temp. the oily liquid will sink and collect
|
||
at the bottom of the beaker. At this point, the remaining acid solution should
|
||
be drawn off using a syringe.
|
||
|
||
7. Fifty more grams of the first acid solution are added to the oily liquid
|
||
while the temp. is slowly being raised to 83 C. After this, the temp. is
|
||
maintained for 30 minutes.
|
||
|
||
8. At the end of this period, the solution is allowed to cool to 60 C, and is
|
||
held at this temp. for another 30 minutes. The acid is then again drawn off,
|
||
leaving once more only the oily liquid at the bottom.
|
||
|
||
9. Thirty grams of sulfuric acid are added, while the oily liquid is gently
|
||
heated to 80 C. All temperature changes must be accomplished slowly and gently.
|
||
|
||
10. Once the desired temperature is reached, 30 grams of the second solution
|
||
are addedEand the temperature is raised from 80 to 104 C, and is held for 3
|
||
hours.
|
||
|
||
11. After the 3 hours, the mixture is lowered to 100 C and is held for 30
|
||
minutes.
|
||
|
||
12. The oil is then removed from the acid and washed in boiling water.
|
||
|
||
13. While washing with boiling water, the TNT will begin to solidify.
|
||
|
||
14. When it starts to solidify, cold water is added to the beaker, so that the
|
||
TNT will form into pellets.. Once this is done, you have a good quality TNT
|
||
which is very stable and can be melted at 82 C.
|
||
----------------------------------------------------------------------------- |