40 lines
1.9 KiB
Plaintext
40 lines
1.9 KiB
Plaintext
|
|
|
|
---PHONE BOMBS -= Exodus =-
|
|
|
|
The phone bomb is an explosive device that has been used in the past to
|
|
kill or injure a specific individual. The basic idea is simple: when the
|
|
person answers the phone, the bomb explodes. If a small but powerful high
|
|
explosive device with a squib was placed in the phone receiver, when the
|
|
current flowed through the receiver, the squib would explode, detonating the
|
|
high explosive in the person's hand. Nasty. All that has to be done is
|
|
acquire a squib, and tape the receiver switch down.
|
|
|
|
Unscrew the mouthpiece cover, and remove the speaker, and connect the squib's
|
|
leads where it was. Place a high explosive putty, such as C-1 (see section
|
|
3.31) in the receiver, and screw the cover on, making sure that the squib is
|
|
surrounded by the C-1. Hang the phone up, and leave the tape in place.
|
|
|
|
When the individual to whom the phone belongs attempts to answer the phone,
|
|
he will notice the tape, and remove it. This will allow current to flow
|
|
through the squib. Note that the device will not explode by merely making a
|
|
phone call; the owner of the phone must lift up the receiver, and remove the
|
|
tape. It is highly probable that the phone will be by his/her ear when the
|
|
device explodes...
|
|
|
|
--IMPROVED PHONE BOMB
|
|
|
|
The above seems overly complicated to me... it would be better to rig the
|
|
device as follows:
|
|
|
|
_________ FIRST UNPLUG THE PHONE FROM THE WALL
|
|
/|-------|\ Wire the detonator IN LINE with the wires going to the earpiece,
|
|
~ | | ~ (may need to wire it with a relay so the detonator can receive
|
|
@@@@@@@@ the full line power, not just the audio power to the earpiece)
|
|
@@@@@@@@@@
|
|
@@@@@@@@@@ Pack C4 into the phone body (NOT the handset) and plug it back
|
|
in. When they pick up the phone, power will flow through the
|
|
circuit to the detonator....
|
|
|
|
|