44 lines
1.6 KiB
Plaintext
44 lines
1.6 KiB
Plaintext
Making Your Very Own Bong That You Can ReUse
|
|
By PHiSH
|
|
|
|
Making a Bong is really easy... :)
|
|
|
|
Materials Needed:
|
|
1: 1/4" aluminum tubing (that's 1/4" on the outside... not the inside)
|
|
(Make sure this is ALUMINUM tubing an NOT COPPER, Heating copper tubing
|
|
and inhaling the fumes can kill you!!)
|
|
2: Glass Bottle with fitting lid or double holed stopper (holes must be 1/4")
|
|
3: Drill + 1/4" Drill Bit OR 1/4" punch
|
|
4: 1/4" Socket for a Socket Wrench, best to use the biggest size you can
|
|
find that still fit's the 1/4" wrench
|
|
5: Fine screen, like the one you'd use in a pipe, available at most
|
|
bong/pipe selling stores
|
|
|
|
Procedure:
|
|
1: Drill two 1/4" holes in the lid
|
|
2: Cut about 4" (depending on the size of your bong) of Al. tubing
|
|
3: Curve the 4"'s os tubing to 90 degrees
|
|
4: Put the lid with the holes onto the glass bottle
|
|
5: Put the 4" Curved piece of tubing into one of the holes
|
|
6: Straighten the rest of the tubing and put it into the other hole
|
|
7: Slide the big piece of tubing all the way down so it touches the bottom
|
|
8: Curve the bottom of the Big piece just a tad
|
|
9: Cut the top of the big peice of tubing about 1" or 2" above the cap
|
|
10: Put the screen in the big side socket
|
|
11: Put the socket on the end of the big tube
|
|
12: Pull the tube assembly out of the bottle and fill the bottle about
|
|
half full with water
|
|
13: Obtain some Marijuana and smoke it
|
|
|
|
Picture (As best I can draw it)
|
|
__
|
|
\ |_|
|
|
_|_|_
|
|
| | | |
|
|
| | | |
|
|
/ | \
|
|
| | | <----Water Fill Level
|
|
| | |
|
|
| \ |
|
|
^^^^^^^^^
|