72 lines
2.7 KiB
Plaintext
72 lines
2.7 KiB
Plaintext
***************************************
|
||
* How to make a *
|
||
* Portable Silver Box *
|
||
* *
|
||
* By: *
|
||
* The *
|
||
* Phone *
|
||
* Phantom *
|
||
* *
|
||
***************************************
|
||
|
||
This will tell you how to make a portable silver box out of:
|
||
|
||
A Radio Shack touch tone pad
|
||
Some wire
|
||
A Soldering iron
|
||
And a SPDT switch
|
||
|
||
NOTE: You should have an I.Q. above room tempature before attempting
|
||
this. Also, read all of this article before starting.
|
||
|
||
WARNING: This may be hazardous to your freedom.
|
||
|
||
1) Take off the plastic cover that stores the batteries and remove
|
||
the screw that is in the center of the batteries. Now use a screw
|
||
driver to pry open the box.
|
||
|
||
2) Now you should have the two halves in your hands. On the side that
|
||
has the circuit board, it should be held by two clips. Remove the
|
||
circuit board now.
|
||
|
||
3) You should now be able to see the back side of the keypad.
|
||
Connecting the the key pad and the circuit board is a ribben cable.
|
||
With the ribben ends connected to the keypad away from you, count
|
||
from the left over four wires. On the fourth wire, take and cut the
|
||
plastic on either side on the wire. Then desolder it.
|
||
|
||
4) Now stare at the circuit board. Look at the connections of the
|
||
chip. (SEE FIG.) There should be four pins not connected to
|
||
anything. On the ninth pin (first row, first pin) solder a 3 inch
|
||
wire to it. The other end goes to the left side of the spdt switch.
|
||
|
||
5) Go back to the cable. Solder a 2 inch to the ribben cable you just
|
||
took out. This is because it won't reach the switch. The other end
|
||
goes to right side of the switch.
|
||
|
||
6) Now take a two inch wire and solder it to the hole that the cable
|
||
came out of. Becareful not to get solder on the other wires. Now take
|
||
the other end and solder it to the middle of the switch.
|
||
|
||
7) Make a hole in the top of the case to put the switch through. And
|
||
put it back together.
|
||
|
||
THE FIGURE OF THE CHIP.
|
||
THE PIN >9< 10 11 12 13 14 15 16
|
||
1 2 3 4 5 6 7 8
|
||
|
||
(Pretty cool eh?)
|
||
_______________________________________
|
||
Switch the switch left according to the way you soldered it to make
|
||
silver box tones on the 3,6,9, and # keys. Switch it to the right
|
||
for a normal key pad. Switching it to the middle does NOTHING!!!!
|
||
|
||
This silver is small enough to fit in your pocket for phreaking at
|
||
your nearest pay phone or where ever.
|
||
This file is for information only (RIGHT!) ha ha ha!
|
||
|
||
Written by:
|
||
|
||
The Phone Phantom
|
||
Downloaded From P-80 International Information Systems 304-744-2253
|