108 lines
6.1 KiB
Plaintext
108 lines
6.1 KiB
Plaintext
Ü Ü Ü Ü Ü Ü Ü Ü Ü Ü Ü Ü Ü Ü Ü
|
||
ÜÛßßßßßßßßßßßßßßßßßßßßßßßßßßßßÛß \ /
|
||
ÜÛ The Chrome Box Ûß A Portable Self-Contained Device
|
||
ÜÛ 14-JUN-88 Ûß / to Manipulate Traffic Signals \
|
||
ÜÛ Outlaw Telecommandos Ûß / by Remote Control \
|
||
ÜÛ Modem Free Earth Ûß / \
|
||
ÜÛÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÛß -=ð*ð=-
|
||
ß ß ß ß ß ß ß ß ß ß ß ß ß ß ß
|
||
|
||
Emergency vehicles in many cities are now using devices called OptoComs.
|
||
OptoComs are a system of sensors on traffic lights that detect a pattern
|
||
of flashes from vehicle-mounted strobe lights.
|
||
This flash pattern varies from city to city depending on the manufacturer
|
||
of the equipment used. Often the sensors are installed only at major
|
||
intersections. Nevertheless, the Chrome Box, which simulates these strobe
|
||
patterns can often be used to give your car the same priority as an
|
||
ambulance, paramedic van, firetruck or police car.
|
||
Because of the varying patterns on different systems this phile will
|
||
outline a general procedure for making the Chrome Box.
|
||
|
||
Decoding Flash Patterns:
|
||
|
||
First, you need to observe an emergency vehicle in action. You can wait
|
||
until you encounter one by chance, running out to see when you hear a siren,
|
||
or when you pull over in your car to let one pass by. You might wait
|
||
near a fire station for the next emergency to occur. Or, if you are
|
||
very impatient, you can summon one by calling in a false alarm (not
|
||
recommended in areas with limited services - that could divert attention
|
||
from a real emergency). If the OptoComs in your area are the kind with
|
||
a pattern of single flashes at a steady rhythm, you have merely to buy
|
||
a strobe light at Radio Shack & adjust the flash rate until you can
|
||
induce a traffic light to change. If the flash pattern is more complex,
|
||
you can videotape the emergency vehicle & then play back the tape in
|
||
single-frame mode, counting the number of frames between each flash.
|
||
Each video frame is 1/30 of a second, using this you can calculate the
|
||
time between flashes in the pattern. Another way is to count the number
|
||
of flashes (or flash-groups) in one minute and use that to compute the
|
||
rate. Counting video frames will give you a good idea of the spacing of the
|
||
flashes in a complex pattern. For really accurate information, call the
|
||
fire station & ask them, or write to the manufacturer for a service manual,
|
||
which will include a schematic diagram that you can use to build one.
|
||
A good cover story for this is that you are a consultant & one of your
|
||
clients asked you to evaluate Optocom systems, or you could pose as
|
||
a free-lance journalist writing an article.
|
||
|
||
Modifying the Strobe Light:
|
||
|
||
You may not have to modify the strobe at all. But if you need a faster
|
||
flash rate than your strobe allows, open it up & find the large capacitor
|
||
inside. Capacitors are marked in microfarads, abbreviated as mf,mfd or ufd.
|
||
By replacing the capacitor with one of the same voltage-rating (usually
|
||
250 volts or more) and a SMALLER value in microfarads, you can increase the
|
||
flash rate. Halving the microfarads doubles the rate.
|
||
The other component that can be changed is the potentiometer (the speed
|
||
control device with the knob on it). Using a smaller value (measured in
|
||
ohms or Kilohms, abbreviated with the greek letter 'omega' or the letter K)
|
||
will speed up the strobe. There may also be a resistor (small cylinder with
|
||
several colored stripes on it, and wires coming out of each end). Replacing
|
||
this resistor with one of smaller value will also speed up the strobe.
|
||
To generate a complex pattern, you will either have to design and build
|
||
a triggering circuit using IC chips, or rig up a mechanical device with
|
||
a multiple-contact rotary switch and a motor. It HAS been done.
|
||
To modify the strobe for mobile operation the simplest thing is to get
|
||
a 110-volt inverter that will run off of a car battery by plugging into the
|
||
cigarette lighter & run the strobe from that. Or, you can figure out
|
||
(or find in a hobby electronics magazine) a strobe circuit that will run
|
||
from batteries. Battery-powered strobes may also be availble, either
|
||
assembled or as kits.
|
||
|
||
Stealth Technology:
|
||
|
||
Most light sensors and photocells are more sensitive in the infrared area
|
||
of the light spectrum. Infrared (IR) is invisible to the human eye.
|
||
Putting an infrared filter over the strobe light may allow the Chrome Box
|
||
to operate in traffic undetected by police or other observers. IR filters
|
||
can be obtained from military surplus sniperscope illuminators, or from
|
||
optical supply houses like Dow-Corning or Edmunds Scientific Co.
|
||
|
||
Using the Chrome Box:
|
||
|
||
Mounted on your car, the Chrome Box can guarantee you green lights at
|
||
major intersections in cities that have OptoComs.
|
||
Handheld Chrome Boxes may be used to create gridlock by interfering with
|
||
the normal flow of traffic. If you have access to a window overlooking
|
||
a traffic light, you can play pranks by switching the signals at
|
||
inappropriate moments, or you can plug the strobe into an exposed outlet
|
||
at a laundromat or gas station.
|
||
|
||
Some Decoded Patterns:
|
||
|
||
Torrance, California
|
||
Standard large Radio Shack strobe lights are used. Moderately fast rate.
|
||
* * * * * * * *
|
||
|
||
Manhattan Beach,CA
|
||
Flash-pairs in a 4:1 ratio, at a rate of 2 flash-pairs per second.
|
||
* * * * * * * *
|
||
<------ 1 sec ----->
|
||
|
||
******************************************************************
|
||
* Please add any new patterns or info you discover to this Phile *
|
||
******************************************************************
|
||
|
||
Thanks to those who posted observations on the South Bay WWIV's.
|
||
|
||
(Leeched From X-Point BBS 714/993/5311)
|
||
|
||
|