26 lines
1.3 KiB
Plaintext
26 lines
1.3 KiB
Plaintext
===== BAND EXPANSION MODIFICATION FOR ICOM MICRO2 =====
|
||
|
||
1. Remove battery.
|
||
2. Remove 4 screws securing batter. Slide from fron panel.
|
||
3. Remove small black screw below PTT switch.
|
||
4. Carefully separate the fron speaker from the body by pulling front
|
||
and rear down toward battery. Flip it over.
|
||
5. Next remove steel chassis assembly by gently prying up the sides,
|
||
lift up, fold it down.
|
||
6. Solder in new diode next to Q131 and Diode D113. Looking at Diode
|
||
Matrix with top of radio to the top, add diode to the empty pad to
|
||
the left of diode D119. There are 3 points of connection on the
|
||
diode pad. Two on the left and on centered vertically on the right.
|
||
The diode should be installed between the lower left and the right
|
||
centered connection. (Arrow on diode points to right centered connection.)
|
||
7. Reset CPU by following instruction manual page 23.
|
||
|
||
----------------------------------
|
||
|
||
***->Be careful not to transmit out-of-band, or accidentally operate on
|
||
any non-amateur, unless you are authorized to do so.
|
||
|
||
DO NOT JEOPARDIZE YOUR LICENSE!
|
||
RELAYED BY...N0KGX...GENE
|
||
|
||
|