65 lines
2.4 KiB
Plaintext
65 lines
2.4 KiB
Plaintext
===============================================================================
|
||
|
||
|
||
All In One Box
|
||
|
||
BY:
|
||
|
||
Disk Doctor
|
||
|
||
|
||
==============================================================================
|
||
|
||
|
||
Basicly, this should be common sense.. All You have to do is by a small
|
||
box (Preferable a rated box that will keep it from interfering with
|
||
that nice Raidio you carded last week <grin>)
|
||
|
||
If you want to be real cheap about it you can go with just a plywoord
|
||
box... But I highly suggest you use a PC case.. or something that will
|
||
not burn (Overloads?)
|
||
|
||
Then simply assemble that boxes discussed in this file.. Now after you
|
||
do that.. You're gonna have alot of boxes cluttering the old room. What
|
||
to do? Simple.. Getcha a powersupply.. And some switches (on/off) from
|
||
Raidio Shack (Yes pay for them.. They're not that expensive) Now.. if
|
||
you buy you a bread board. (Cards kits can be picked up anywhere. And
|
||
this is the type you should use) Then simply install the box on one of
|
||
these. And incase them in the PC case. Now.. You can drill a hole in
|
||
the case and run the line in there.. and likewise have another hole
|
||
drilled for the line to run back out (Phone that have a hook up for
|
||
more than one regular line can give you some of the parts)
|
||
|
||
Next install the cards.. You *MUST* Use a low voltage power supply
|
||
(These boxes don't need much if any.. And make sure that you check the
|
||
voltage in the circuit.. You can run it to a light bulb if you need
|
||
someplace to disperse some of it!
|
||
|
||
No the simple task.. Where the Disk Drives normaly go simply Hook you
|
||
up some on off switches.. So that you can easily switch between the
|
||
boxes.. This will make life SOOOOOO much easier... I promise..
|
||
|
||
Also if you want to make it easier with the phone lines you can aphro engineer
|
||
a line in. IE run the phone line in to box along the back with them being fully
|
||
exposed.. IE
|
||
|
||
-------------------------------
|
||
|
||
----------------------------------
|
||
|
||
|
||
This allows for a sort of switching system as it were. After this is done..
|
||
Simple solder wires where need and run them to the appropriate box.. you may
|
||
then hook a lever (Like you see in those old Frakenstein movies) to the box to
|
||
allow box priorty over the line..
|
||
|
||
All in all this is pretty simple shit. But just some ideas for you to play
|
||
with....
|
||
|
||
|
||
|
||
|
||
Later
|
||
|
||
Doc
|
||
|