194 lines
8.4 KiB
Plaintext
194 lines
8.4 KiB
Plaintext
|
|
/=/=/=/=/=/=/=/=/=/=/=/=/=/=/=
|
|
Making Nitrous Oxide
|
|
from Tele-Theif Express
|
|
original file from
|
|
Z. DeBuggah from Folo Zone
|
|
/=/=/=/=/=/=/=/=/=/=/=/=/=/=/=
|
|
416/283-1854
|
|
|
|
Making Lauging Gas/Whip-its/Nirous Oxide/etc.
|
|
---------------------------------------------
|
|
|
|
WHAT YOU NEED:
|
|
--------------
|
|
|
|
o Ammonium Nitrate (NH4NO3) - get a good grade, it's a fertilizer and comes
|
|
in 50lb. bags. Also available from lab supply companies like VW&R or
|
|
American Scientific at a much greater cost.
|
|
|
|
o Clean sand. Fairly fine grained (30 mesh or finer.) If you collect your
|
|
and you get fresh water sand, it will be necessary to wash it thoroughly
|
|
with water then dry it before using. You must also wash the sand before
|
|
reusing it.
|
|
|
|
o Electric hot plate (500 to 2500 watt) with variable heat.
|
|
|
|
o Stainless steel dial thermometer. (This is the only metal item which may
|
|
be used.) It must go to 250 C (450 F). Select the Erlenmeyer flask (next
|
|
item) and the thermometer so that the thermometer can reach at least
|
|
within 1/16" of the bottom of the flask through the stopper.
|
|
|
|
o A 2000 to 4000 ml PYREX or KIMAX Erlenmeyer flask.
|
|
|
|
o Several feet of 3/8" clear vinyl or surgical rubber tubing.
|
|
|
|
o At least 4 8mm ID glass or plastic tubing "T's".
|
|
|
|
o 1 120 degree bend 8mm ID PYREX glass elbow, with about 3" of tubing on
|
|
each side of the bend.
|
|
|
|
o 7 6-8" long pieces of 8mm ID glass or plastic tubing.
|
|
|
|
o 3 6-8 feet long 1.5" to 2" diameter glass or clear plastic pipes.
|
|
|
|
o 1 two hole rubber or neoprene stopper to fit the top of the Erlenmeyer
|
|
flask. One hole should fit the 8mm ID PYREX glass elbow, and the other
|
|
hole should fit the stainless steel dial thermometer.
|
|
|
|
o 6 one hole rubber or neoprene stoppers that will fit the ends of the
|
|
clear plastic or glass pipes. The holes in the stoppers must fit the
|
|
straight 8mm ID glass or plastic tubes.
|
|
|
|
|
|
NH NO ----------------------> N O + 2*H O
|
|
4 3 2 2
|
|
|
|
Ammonium nitrous two
|
|
Nitrate oxide water
|
|
|
|
|
|
Set-up
|
|
------
|
|
|
|
If you've gotten this far - remember - you MUST meet the exact quiality
|
|
specifications of the equipment list. If you really want a do-it-yourself
|
|
nitrous oxide generator, you want a sturdy set-up you can over and over and
|
|
enjoy again and again!
|
|
|
|
See IFF files included for the diagram of the set-up.
|
|
|
|
Assembly
|
|
--------
|
|
|
|
NOTE: When inserting tubing through stopper holes, ALWAYS WRAP AND HOLD THE
|
|
TUBING WITH A CLOTH. Also moisten the tip of the tubing and the
|
|
stopper hole with glycerin, soap, or spit. (never oil)
|
|
|
|
1> Into the stopper with two holes, inset the thermometer far enough so
|
|
that when the stopper is put into the Erlenmeyer flask, it almost
|
|
touches the bottom of the flask (but don't allow it to touch), and then
|
|
insert one end of the glass elbow far enough through the stopper so that
|
|
it sticks out 1/4" to 1/2".
|
|
|
|
2> Into the six one-hole stoppers, insert a piece of the 8mm ID glass (or
|
|
plastic) tubing so that 1/2" to 3/4" protrudes from the narrow end of
|
|
the stopper.
|
|
|
|
3> Now select your set-up space so that there is 1.5 feet of space clear in
|
|
all directions around the hotplate, so that the three scrubber pipes can
|
|
lie side by side where they will not be knocked over.
|
|
|
|
4> Take approximately 2 feet of the 3/8" flexible tubing and connect
|
|
one end to the glass elbow in the two-hole stopper, and the other end to
|
|
the middle of one of the 8mm ID glass (or hard plastic) "T's".
|
|
|
|
5> With short pieces (select lengths for a neat fit) of 3/8" tubing and
|
|
another 8mm "T" assemble the INLET SET manifold and connect it to the
|
|
bottom end of the scrubbers. Stoppers may then be inserted into the
|
|
lower end of the scrubber pipes.
|
|
|
|
6> Elevate the OUT end of the scrubber pipes so that the upper end is 6" to
|
|
8" above the IN end, but no more, and then fill the pipes with water
|
|
until they are full within 4" to 8" of the top (outlet) end, and insert
|
|
the outlet stoppers. Try to fill all the scrubbers equally full.
|
|
|
|
7> With short pieces of 3/8" tubing and two 8mm ID "T's", prepare and
|
|
connect the OUTLET SET manifold to the scrubbers similar to the way the
|
|
set was connected in step 5.
|
|
|
|
8> To the last "T" of the OUTLET SET (of "T's" manifold), connect a fairly
|
|
long piece of 3/8" tubing to reach a "safe" location (where connection
|
|
and disconnection of the receiver bags will not disturb the scrubbers)
|
|
and secure it. Then put the last piece of 8mm ID hard tubing into the
|
|
free end.
|
|
|
|
9> Finally, prepare several receiever bags by inserting about an 8" piece
|
|
of tubing into the top so that 3" or 4" sticks out of the bag and secure
|
|
it in place with a rubber band.
|
|
|
|
> > > > > > > > > > > > > > > CONGRATULATIONS < < < < < < < < < < < < < < <
|
|
|
|
You are now the proud owner of your very own Nitrous Oxide Generator.
|
|
|
|
Operation
|
|
---------
|
|
|
|
First, prepare a quantity of a mixture containing 1/3 sand and 2/3
|
|
ammonium nitrate. Then pour enough of the mixture into the erlenmeyer flask
|
|
to give 1.5" to 2" in the bottom of the flask. Put the flask onto the
|
|
hotplate, and insert the two-hole stopper, firmly but not too tight. <<This
|
|
stopper is your safety valve while the system is operating.>> --BUT--
|
|
|
|
WARNING-WARNING-WARNING-WARNING-WARNING-WARNING-WARNING-WARNING-WARNING
|
|
W W
|
|
A Once the heating of the mixture in the erlenmeyer flask has started A
|
|
R you MUST REMOVE the two-hole stopper from the flask before turning R
|
|
N off the heat. Otherwise as the flask starts to cool off, it will N
|
|
I draw water from the scrubbers back into the hot flask and may crack I
|
|
N or EXPLODE the erlenmeyer flask with the steam formed inside. N
|
|
G G
|
|
WARNING-WARNING-WARNING-WARNING-WARNING-WARNING-WARNING-WARNING-WARNING
|
|
|
|
Now you may begin heating the flask. Turn the hotplate to medium or
|
|
medium-high and watch the thermometer. If the temperature climbs very fast,
|
|
turn the hotplate down, but be patient about turning it up. Occasional
|
|
bubbles will be noted going through the scrubbers as the air in the system
|
|
expands. At 210 C (410 F) a yellowish to orange-brown will begin filling
|
|
the flask, and the bubbling throught the scrubbers will become steady.
|
|
|
|
At this time, adjust the upper end heights of the scrubber tubes so that
|
|
each one gets about the same amount of gas passing through it. Keep your
|
|
eye on the temperature, and it should not climb much over the 210-220 C
|
|
(410-430 F) marks. Also the gas at the top of the scrubbers MUST BE
|
|
PERFECTLY COLORLESS! Otherwise, turn down the heat setting. If the gas flow
|
|
is too low to give a steady flow throught all three scrubbers, increase the
|
|
heat slightly.
|
|
|
|
Once you've run your system a time or two, you'll know what your
|
|
operating settings are.
|
|
|
|
As soon as the gas flow is steady and clean, connect a receiving bag to
|
|
the final outlet tube, and allow the bag to fill. It may be necessary to
|
|
add more amonium nitrate-sand mixture to the flask from time to time -- wear
|
|
gloves as the flask will be HOT when removing the stopper. It is also a
|
|
good idea to turn off the hotplate while the stopper is out of the flask.
|
|
|
|
Once you've filled a few bags with laughing gas, you're ready to try some.
|
|
Just inhale from the bag and hold it in as long as you can. You'll know
|
|
what to do from there.
|
|
|
|
It's also rumored that use of marijuana, hash, cocaine, LSD or various
|
|
other drugs will intensify and lengthen the nitrous oxide experience. It
|
|
might also be possible that repeated inhalations of nitrous oxide may cause
|
|
a more intense reaction.
|
|
|
|
My predictions:
|
|
|
|
Mixing nitrous oxide inhalations with the use of:
|
|
|
|
Marijuana: euphoric state approximating an intensified marijuana 'high'.
|
|
Hashish: a great happiness and cheer overwhelms you for about an hour.
|
|
Cocaine: TREMENDOUS paranoia and depression.
|
|
LSD: heightened senses and awareness. Hallucinations involving whipped
|
|
cream.
|
|
Alchohol: hopefully cause immediate death. There's no excuse to use
|
|
alchohol when there are so many other more effective and tastier drugs.
|
|
|
|
This file brought to you by
|
|
Tele-Theif Express : 416-283-1854
|
|
|
|
original file from
|
|
Z. DeBuggah from the Folo Zone Gang
|
|
|