83 lines
5.0 KiB
Plaintext
83 lines
5.0 KiB
Plaintext
Newsgroups: alt.drugs
|
|
|
|
|
|
Heroin purification to nearly USP
|
|
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
|
|
This is as complete and as accurate as I can remember, it has
|
|
been something like 9 years since I have used heroin. The
|
|
process I used for purification was straight forward.
|
|
Diacetylmorphine can exist in two forms, an insoluable base, or
|
|
a soluable salt. Often it contained a plethera of other agents
|
|
like pieces of broken glass, pieces of foil, dirt, wood, metal,
|
|
mannitol, lactose, maltose, sand, you get the idea. The first
|
|
stage of the process I used was to make sure the
|
|
diacetylmorphine I received was totally converted to a soluable
|
|
hydrochloride salt. The heroin I usually received was a brown
|
|
powdered heroin, sometimes off white, very little vinegar smell.
|
|
Today all you can find is a black crud that reeks with a vinegar
|
|
(acetic) odor. The way I made sure it was a soluable salt was
|
|
to drop enough 28% hydrochloric acid to make it wet. This
|
|
insured that I would not waste any of the available drug, but
|
|
would remove most if not all of the cut. I think that it would
|
|
be better for me to detail it in a procedural manner. FYI,
|
|
hydrochloric acid can be purchased in gallon jugs at hardware
|
|
stores under the name Muriatic acid, 28%.
|
|
|
|
First weigh out one gram of heroin from the stock you received
|
|
from your supplier. Place this gram into a 13 x 100mm test
|
|
tube. Add a few drops of 28% hydrochloric acid until it is
|
|
evenly damp. Allow to react for a minute or two. Next add 5 ml
|
|
distilled water, place your thumb over the end and carefully
|
|
shake to dissolve all that will dissolve into the water. Allow
|
|
the insoluables to settle. Using a pipette, remove and transfer
|
|
as much of the liquid to a fresh test tube leaving the solids
|
|
behind. Dispose of the undissolved remains in the first test
|
|
tube. Slowly add via pipette, one drop at at time, ammonium
|
|
hydroxide (water clear household ammonia) until the white
|
|
precipitate ceases production. Add several more drops at this
|
|
point just to be sure. Shake gently to be sure that all the
|
|
solution is evenly ammoniated. The solution should look milky.
|
|
Now add 100 ml ethyl ether (some kinds of diesel starting
|
|
fluids, read the label) to a 150 ml beaker. Dump the milky
|
|
liquid into the ether and stir briskly and allow the water to
|
|
settle and collect on the bottom. The water will turn clear.
|
|
Using a glass pipette, remove this water from the bottom of the
|
|
beaker and dispose of. Now mix up a solution of 5ml 28%
|
|
hydrochloric acid and 5ml distilled water and add this to the
|
|
ether in the beaker. Stir briskly keeping as much acid/water
|
|
suspended as possible for several minutes. Allow the water/acid
|
|
to collect on the bottom of the beaker. Using a glass pipette,
|
|
remove this water layer from the bottom of the ether and
|
|
transfer to a glass petri dish. Transfer the ether back to its
|
|
storage bottle for reuse. It will still contain small amounts
|
|
of heroin base, so don't throw it out. Recycle! Slowly add
|
|
small portions of sodium bicarbonate (baking soda) to the
|
|
water/acid solution in the petri until you don't notice any more
|
|
bubbles being formed. Place the glass on a warm surface, and
|
|
allow to evaporate. The residue will be diacetylmorphine
|
|
hydrochloride and salt. Table salt is a by-product of the
|
|
reaction and will not hurt you at all when injected. Scrape up
|
|
the residue and weigh it. Yield from one gram of smack (yea, we
|
|
called it that) would be anything from 100 to 300 mg, rarely
|
|
more. Place 100 mg of this powder in a test tube, add 10 cc
|
|
sterile isotonic water for injection (available OTC at drug
|
|
stores) and heat to boiling. Transfer this liquid while still
|
|
hot using a syringe (available OTC at some drug stores) to a 10
|
|
ml rubber stoppered empty sterile ampoule (available OTC at drug
|
|
stores). To use this drug which is 10mg/ml, extract with a
|
|
sterile syringe as much drug as you wish to use. 10 mg would
|
|
send me flying believe it or not. 2.5mg (1/4 cc) was usually
|
|
enough to keep me "happy" and was my normal dose. 20mg was the
|
|
most I could take safely in my opinion, and was a waste of drug
|
|
and money. Normally, for most 150-170 lb males, 2.5 mg is more
|
|
than enough in my opinion. Using heroin in this manner avoids
|
|
the problems associated with "street use" and will keep your
|
|
body healthy and safe, reducing the risk of disease and
|
|
overdosage.
|
|
|
|
My memory is pretty good, and I think I covered all the bases
|
|
here, but I may have made a mistake somewhere. Overall I think
|
|
this is an accurate method, to the best of my ability to remember.
|
|
|
|
|