54 lines
2.0 KiB
Plaintext
54 lines
2.0 KiB
Plaintext
______________________________________________________________________
|
|
STACKER NOTE Stac Electronics Technical Note
|
|
|
|
Subject: Installing Stacker on an IBM PS/1
|
|
|
|
Tech020- 2/20/92
|
|
Page 1 OF 1
|
|
______________________________________________________________________
|
|
|
|
STACKER works great on an IBM PS/1. However, There are a few things
|
|
you must do before and after installing STACKER on an IBM PS/1. The
|
|
following step-by-step procedure will prepare your PS/1 for STACKER:
|
|
|
|
Procedure:
|
|
Note: Step 1 is recommended, but not required.
|
|
|
|
1. Start IBM DOS from the 4th quadrant screen. Click on "Backup and
|
|
Restore Your Fixed Disk" and press <Enter>. Follow the prompts that
|
|
you are given to backup all of the files on your fixed disk.
|
|
NOTE: The number of diskettes will vary depending on the amount of
|
|
data on your hard disk.
|
|
|
|
2. Press <Shift>+<F9> to get to the DOS prompt after completing the
|
|
backup.
|
|
|
|
3. Type c:\dos\CUSTOMIZ and press the <Enter> key to setup the system.
|
|
(Customiz can also be run from the IBM DOS quadrant.)
|
|
|
|
4. The third line from the bottom of the screen says "Read
|
|
Config.sys:". Click on "From Disk".
|
|
|
|
5. The next line down says "Read Autoexec.bat:". Click on "From Disk".
|
|
|
|
6. The last line says "Disk to read from:". Click on "C:".
|
|
|
|
7. Press <Enter> to save the changes and exit CUSTOMIZ.
|
|
|
|
8. Restart your system by pressing <Ctrl>+<Alt>+<Del>.
|
|
NOTE: At this point your computer will boot directly to the DOS
|
|
prompt.
|
|
|
|
9. You can now install STACKER by inserting the STACKER diskette and
|
|
typing: A:INSTALL /B=C
|
|
At the end of the STACKER install let STACKER reboot
|
|
to access the STACKER drive. This will again take you to the DOS
|
|
prompt.
|
|
|
|
10. To restore the PS/1 system menu, edit the Config.sys on drive C:
|
|
and insert the line: INSTALL=D:\SHELLSTB.COM (STACKER 2.0 users can use
|
|
SEDIT to modify Config.sys.)
|
|
|
|
11. Restart the system for changes to take affect.
|
|
|