59 lines
2.3 KiB
Plaintext
59 lines
2.3 KiB
Plaintext
|
|
|
|
STAC ELECTRONICS
|
|
TECHNICAL SUPPORT BULLETIN
|
|
|
|
NUMBER: 006
|
|
SUBJECT: LOADHI
|
|
|
|
DATE: July 9, 1991
|
|
TIME: 12:47 PM
|
|
|
|
SOURCE: Tech Support, Engineering, User's Manual
|
|
SUPERCEDES/
|
|
SUPERCEDED BY:
|
|
RELEASE STATUS: Public
|
|
|
|
TITLE:
|
|
Loading STACKER into high memory.
|
|
|
|
OVERVIEW:
|
|
To conserve base memory, it is possible to load the STACKER driver into
|
|
high memory (between 640K and 1024K) on systems with 80286 chips and
|
|
higher. Appropriate memory management software (QRAM, MOVE'EM, QEMM386,
|
|
386MAX) and hardware are needed. Loading high on an 80286 machine
|
|
requires hardware support for Expanded Memory Specification (EMS) 4.0
|
|
(see User's Manual, "Loading STACKER into High Memory").
|
|
|
|
Note: For loading high using MS-DOS 5.0's DEVICEHIGH, see TECH015.DOC,
|
|
"Loading STACKER into upper memory with MS-DOS 5.0".
|
|
|
|
ISSUES/COMMENTS:
|
|
Potential problems with loading high are:
|
|
-crowding in high memory, resulting in disk-read errors;
|
|
-erratic behavior of memory-intensive programs;
|
|
-exclude-phrases omitted from the memory manager device line (STACKER
|
|
coprocessor version only);
|
|
-load-high driver not invoked in STACKER.COM device driver line;
|
|
-STACKER cache (/M=xx) specified at excessive size;
|
|
-insufficiently large block of contiguous memory between 640K and 1024K.
|
|
|
|
RECOMMENDED ACTIONS:
|
|
1) Consult documentation for memory manager to verify syntax in
|
|
CONFIG.SYS. (User's Manual, page 33, shows examples of modification to
|
|
STACKER line only.)
|
|
|
|
2) If applicable, edit load-high driver line to exclude range used by
|
|
coprocessor card (see User's Manual, "Re-enabling Memory Managers").
|
|
Note that the correct syntax for the AT&T 6300's AEMM.SYS is /X=addr-
|
|
addr.
|
|
|
|
3) Verify syntax of load-high statement in STACKER.COM device driver line
|
|
(see User's Manual, "Loading STACKER into High Memory").
|
|
|
|
4) Reduce size of STACKER disk cache (/M=xx switch in STACKER.COM device
|
|
driver line).
|
|
|
|
5) To verify load-high status, use a memory-mapping utility such as
|
|
Quarterdeck's MANIFEST. If Interrupts 25 and 26 are at a segment value
|
|
above A000, then STACKER is loaded high. |