31 lines
1.2 KiB
Plaintext
31 lines
1.2 KiB
Plaintext
=============================================================================
|
|
|
|
AST RESEARCH, INC. TECHNICAL BULLETIN #0788 11-17-92
|
|
|
|
=============================================================================
|
|
|
|
|
|
AST 486 SYSTEMS WITH IBM'S 5250 EMULATION CARD
|
|
|
|
|
|
If an IBM 5250 adapter is installed in an AST 80486-based system, errors may
|
|
occur while accessing a high-density floppy drive. The DOS error generated
|
|
is "FAILURE READING DRIVE X: ABORT, RETRY, IGNORE, FAIL", where "X" is the
|
|
drive to which access is being attempted.
|
|
|
|
The problem occurs because the IBM 5250 emulation card, which defaults to
|
|
using IRQ 5, interferes with the operation of the floppy controller (at IRQ
|
|
6), causing DMA overruns.
|
|
|
|
To resolve this problem the following change needs to be made to the
|
|
configuration of the PC Support program.
|
|
|
|
In the STARTPCS batch file, at the line "E5250AH.COM" add the switch
|
|
"/L7". The command line should read "E5250AH /L7". A capital "L" must
|
|
be used.
|
|
|
|
This effectively changes the IRQ used by the IBM5250 adapter board
|
|
to 7. Note that no other device in the system should be using this
|
|
interrupt.
|
|
|