49 lines
3.7 KiB
Plaintext
49 lines
3.7 KiB
Plaintext
Phile 2 of 4 Audio Surveillance
|
||
------------==========SANctuary===============------------------
|
||
Audio is the most common surveillance method in use. Most listening devices depend on some form of electronics, and it is important to understand the
|
||
usual steps to audio electronic surveillance. It is basically a 5 step process.
|
||
1) Input- usually a microphone
|
||
2) Preamplifier- used to boost the nominal signal of a mic to usable levels
|
||
3) Processing- eliminates excess noise and unwanted sounds from the output
|
||
4) Output- Headphones, recorder, transmitter, etc.
|
||
5) Post-processing (sometimes)
|
||
|
||
This phile will deal with preamplification. Preamplifiers boost the signal from the input to a usable level. Most microphones and sensors, such
|
||
as phototransistors in light transmission bugs, give a signal that lacks power to do anything useful. The electricity generated by the needle of a
|
||
record player can't drive the speakers of your stereo system.
|
||
The main factors of preamplification are gain and noise. Gain is the increase in signal given by the preamplifier. Noise is unwanted sound that
|
||
the preamp generates. A good preamp can make up for a mediocre mic or a bad signal due to the location of the target with relation to he mic, but
|
||
nothing can compensate for a bad preamp. A good preamp has high gain and low noise. There is no limit to the amount of gain that can be applied, but
|
||
noise and electrical breakdown limit the practical application of it. Noise increases with gain, so the limit is where noise overwhelmes the signal.
|
||
Electrical breakdown occurs when gain is so high that inaudible ultrasonic feedback causd by the location of the components with relation to each
|
||
other causes the preamp to shut down. Electrical breakdown also occurs when gain is so high that oscillation occurs and a squeal is sent through the
|
||
mic or speaker. That can sometimes be lessened by shielding or changing the location of the mic.
|
||
Operational amplifiers (op Amps) are often used because they are inexpensive, simple to use, easier to handle, and offer higher gain and lower
|
||
noise than normal-component amplifiers. Op Amps are integrated circuits (ICs) that were originally developed for use in analog computers in the
|
||
1940s. They are high performance linear amplifiers with 2 inputs, allowing for inverted and non-inverted output (negative and positive gain). The
|
||
gain is determined by a resistor that feeds some of the amplified signal back to teh inverting input. The smaller the resistor, the lower the gain.
|
||
An Op Amp amplifies the difference between the input and ground. This may seem complicated, but it actually makes amplifier design much simpler.
|
||
Even a novice could design a simple amplifier using only the Op-amp's data sheet. It is important to keep the battery leads short, but most amps
|
||
avoid that restriction by using a capacitor to keep the input from oscillating. Op Amps are the components that make miniature bugs posible.
|
||
Well, I guess that'll do it for this phile. Watch for the rest of the series by,
|
||
|
||
|
||
The Gaurdian!
|
||
|
||
-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-
|
||
+++++++++++++++++++++++ SANctuary +++++++++++++++++++++++++++++++++++
|
||
-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-
|
||
|
||
Oi! The Gaurdian is really moving quick with these survelence philes!
|
||
Hope you enjoy them!!!
|
||
|
||
Call the SANctuary WORLD HQ!!! HELLFIRE BBS!!! (908) 495-3926
|
||
|
||
----===Red===----
|
||
|
||
|
||
EAT THE RICH!!!
|
||
-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-
|
||
==========================SANctuary==================================
|
||
-=-=-=-=-=-=-=-==-=-=-=-=-=-=-=-=-=-==--=-=-=-=-=-=-=-=-=--=--=-=-=-=
|
||
|