51 lines
1.8 KiB
Plaintext
51 lines
1.8 KiB
Plaintext
Pipe Hand Grenade by the Jolly Roger
|
|
|
|
Hand Grenades can be made from a piece of iron pipe. The
|
|
filler can be of plastic or granular military explosive,
|
|
improvised explosive, or propellant from shotgun or small arms
|
|
munition.
|
|
|
|
Material Required:
|
|
-----------------
|
|
|
|
Iron Pipe, threaded ends, 1-1/2" to 3" diameter, 3" to 8" long.
|
|
Two (2) iron pipe caps
|
|
Explosive or propellant
|
|
Nonelectric blasting cap (Commercial or military)
|
|
Fuse cord
|
|
Hand Drill
|
|
Pliers
|
|
|
|
Procedure:
|
|
---------
|
|
|
|
1) Place blasting cap on one end of fuse cord and crimp with
|
|
pliers.
|
|
|
|
NOTE: To find out how long the fuse cord should be, check the time
|
|
it takes a known length to burn. If 12 inches burns in 30 seconds,
|
|
a 6 inch cord will ignite the grenade in 15 seconds.
|
|
|
|
2) Screw pipe cap to one end of the pipe. Place fuse cord with
|
|
blasting cap into the opposite end so that the blasting cap is
|
|
near the center of the pipe.
|
|
|
|
NOTE: If plastic explosive is to be used, fill pipe BEFORE
|
|
inserting blasting cap. Push a round stick into the center of the
|
|
explosive to make a hole and then insert the blasting cap.
|
|
|
|
3) Pour explosive or propellant into pipe a little bit at a time.
|
|
Tap the base of the pipe frequently to settle filler.
|
|
|
|
4) Drill a hole in the center of the unassembled pipe caplarge
|
|
enough for the fuse cord to pass through.
|
|
|
|
5) Wipe pipe threads to remove any filler material. Slide the
|
|
drilled pipe cap over the fuse and screw handtight onto the pipe.
|
|
|
|
Ready to go!
|
|
|
|
--------------Jolly Roger
|
|
|
|
|