136 lines
5.8 KiB
Groff
136 lines
5.8 KiB
Groff
|
|
[][][][][][][][][][][][][][][][][][][][][][][][][][][][]
|
|
[] []
|
|
[] ___ |\ []
|
|
[] / he |/estructors []
|
|
[] []
|
|
[] by Dragon Master []
|
|
[] []
|
|
[][][][][][][][][][][][][][][][][][][][][][][][][][][][]
|
|
|
|
|
|
|
|
Have you ever tried to make a bomb, something that actually goes BOOM!?
|
|
Then find out that it only flares up? The Destructor is a simple yet powerful
|
|
bomb to make, using general components found at most hobby stores.
|
|
|
|
The following is all you need to make one Destructor:
|
|
|
|
1 CO2 Cartridge - Used in BB guns - come in a pack of five - Target sells em
|
|
for $1.50 a pack.
|
|
|
|
2 Size D Estes model rocket engines - found in most hobby stores where model
|
|
rockets are sold. (Any size will work but
|
|
D's have the most powder)
|
|
|
|
2 Solar ignitors - usually come with the engines - used to ignite the bomb
|
|
|
|
1 Bottle of fastdrying model glue
|
|
|
|
1 Scissors
|
|
|
|
1 Funnel
|
|
|
|
1 roll of masking tape
|
|
|
|
1 hammer
|
|
|
|
1 container (jar, cup, glass)
|
|
|
|
1 20 foot wire (+ and -)
|
|
|
|
1 6 volt (or 12 volt) lantern battery
|
|
|
|
-------------------------------------------------------------------------------
|
|
|
|
Procedure:
|
|
|
|
The CO2 cartridge is the body of the bomb and when it explodes will fragment
|
|
scraple.. so stand back.. Metal flies!!
|
|
|
|
If you have a CO2 BB gun then you will have many empty cartridges. For those
|
|
of you who have never bought CO2 cartridges you will have to find some other
|
|
way of emptying them. I have done this on accident before, simply insert a nail
|
|
in the top of the cartridge and watch the CO2 gas come out!! Very cold if you
|
|
let it touch you. I do not suggest doing it this way, so if possible, ask a
|
|
friend who has a CO2 BB gun for their empty CO2 cartridges.
|
|
|
|
Make the hole bigger:
|
|
Once you have an empty cartridge you have to make the hole bigger, otherwise
|
|
it is very difficult to get the explosive compounds into the cartridge. Take a
|
|
nail and pound the hole bigger. The size of the hole is very important. If it
|
|
is too big the cartridge will act as a rocket instead of a bomb.
|
|
|
|
Prepare the explosive ingrediants:
|
|
Unroll the model rocket engines with a pocket knife, until you have the black
|
|
chunck of boosting compound. Throw away the unrolling paper. You may remove the
|
|
block of clay since this is not explosive. Powder the chunk with the hammer
|
|
until you have fine powder. To make the fine powder, lay down some wax paper
|
|
on the floor. Find a screen mesh, and filter the powder, leaving the big pieces
|
|
on top and the fine powder on the wax paper. Then pour the powder on the wax
|
|
paper into a container. After you have the two size D engines powdered and in
|
|
the container you are ready to put the powder into the CO2 cartridge.
|
|
|
|
Get the ingrediants in the cartridge:
|
|
Make a funnel out of paper (a floppy disk jacket works well, with the end
|
|
clipped off) and tape it around the end of the cartridge. Slowly pour the
|
|
powder from the container into the funnel. You may have to use a toothpick to
|
|
help the powder through the funnel and into the cartridge. If your powder is
|
|
not fine enough it might jam in the hole and you will have to remove the funnel
|
|
and clear the passage. Shake the cartridge every so often until you can't hear
|
|
the powder in there. The cartridge is now full of explosive powder.
|
|
|
|
Prepare the ignitor:
|
|
Clip the paper protector of the ignitor with a scissors and bend the wires so
|
|
they are relatively straight. (Be careful not to break the ignitor when bending
|
|
the wires) Coat the ignitor with glue except for the ends, and let it dry for a
|
|
few minutes. Then insert the ignitor into the cartridge leaving the ends
|
|
exposed. The tip of the ignitor must touch the powder for the powder to ignite.
|
|
This should be no problem if you have enough powder in the cartridge. Put glue
|
|
around the ignitor and the tip of the cartridge and let dry.
|
|
|
|
Connecting the bomb:
|
|
Then bend the end wires of the ignitor and connect to your 20 foot wire.
|
|
Put tape around the end wires and cartridge. The Destructor is now ready to
|
|
detonate.
|
|
Detonating the bomb:
|
|
When you have found a place to detonate The Destructor, stretch the
|
|
wire the full 20 feet and then touch both wires to the two negative and postive
|
|
connectors. This will send a 6 volt charge through the wire and to the ignitor.
|
|
The ignitor will ignite the explosive compounds in the cartridge and in a
|
|
matter of seconds........ BOOM!!!!!!!!!!!!!!
|
|
|
|
|
|
-------------------------------------------------------------------------------
|
|
|
|
There are many, many uses for The Destructor and I'm sure you have one..
|
|
|
|
Detonating it under water and watch the fish float to the top. (It actually
|
|
does explode under water, if ya put enuff tape around it)
|
|
|
|
Putting it in someones mailbox.. hehe..
|
|
|
|
Putting it in a glass jar and watch the glass fly 50 feet up in the air.
|
|
|
|
Burying it a foot under ground and watch the sand and rocks fly 50 feet up in
|
|
the air. (hand grenade simulation) heh..
|
|
|
|
Lowering it into a manhole and hear it echo all over the city.. manholes
|
|
actually jump up from the force..
|
|
|
|
-------------------------------------------------------------------------------
|
|
|
|
|
|
THE WRITER OF THIS FILE IS NOT RESPONSIBLE FOR THE DESTRUCTION CAUSED BY THE
|
|
DESTRUCTOR. YOU AND YOU ALONE ARE RESPONSIBLE FOR THE USE OF THIS INFORMATION.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|