42 lines
1.7 KiB
Plaintext
42 lines
1.7 KiB
Plaintext
EXPLOSIVE PENS
|
|
|
|
Here are the instructions for building a device no agent should be
|
|
without. From the mind of "Q" himself, a device for your evaluation.
|
|
|
|
Materials......
|
|
|
|
[1]-(1) "Felt" Tip Pen
|
|
[2]-(1) "Ball" Point Pen
|
|
[3]-(1) High quality firecracker!
|
|
[4]-(1) 8 gram measure potassium parmagranite (optional)
|
|
[5]-(x) Scotch Tape
|
|
[6]-(1) Large Paper Clip
|
|
[7]-(2) Packages of matches
|
|
[8]-(1) Pair of scissors
|
|
[9]-(1) Length of Beige thread
|
|
|
|
Assembly......
|
|
|
|
[1]- Use thread to friction saw the felt tip pen in half at the point
|
|
where the cap "snaps" onto the pen. (about mid-section)
|
|
[2]- Remove the innerts of the felt tip pen, and throw them away.
|
|
[3]- Pull the innerts out of a bic ball point pen and remove the ball
|
|
point assembly at the front of the pen.
|
|
[4]- Use scissors to widen the hole in the "felt" end of the pen. Insert
|
|
the ball assembly and make sure it is a tight fit. It should now
|
|
look as if the felt tip pen was constructed as a ball point pen.
|
|
[5]- Cut off abrasive strips from the packs of matches. It is best if they
|
|
have not been used. Tape these to the top of the firecracker near
|
|
the fuse, the strips should run parallel to the outstreched fuse.
|
|
Wrap fuse over the top of one strip and tape down so fuse runs parallel
|
|
to abrasive strips.
|
|
[6]- Unbend paperclip and tape a match to the metal rod, the match should
|
|
be parallel to the rod and it should be taped tight using as little
|
|
tape as possible.
|
|
[7]- Insert the match head 1/5 of the way between the abrasive strips
|
|
and wrap tapou too will have to take
|
|
a nice long shower.
|
|
|
|
|
|
|