285 lines
9.2 KiB
Plaintext
285 lines
9.2 KiB
Plaintext
***^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^***
|
||
*** C.I.A. FIELD EXPEDIENT ***
|
||
*** METHODS FOR ***
|
||
*** EXPLOSIVES PREPARATIONS ***
|
||
*** SECTION I ***
|
||
***^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^***
|
||
|
||
Converted to text file by
|
||
The Cheshire Cat
|
||
|
||
PREPARATION OF LEAD PICRATE
|
||
|
||
Lead Picrate is used as a primary explosive in the fabrication of detonators.
|
||
It is to be used with a booster explosive such as picric acid or RDX.
|
||
|
||
MATERIALS REQUIRED (For 1 detonator):
|
||
|
||
- Litharge (lead monoxide) (field prepared; also is used in plumbing and
|
||
ceramic cements)
|
||
- Picric Acid (field prepared)
|
||
- Wood alcohol (methanol) (some antifreezes and paint removers)
|
||
- Wooden or plastic rod
|
||
- Dish or saucer (china or glass)
|
||
- Teaspoon
|
||
- Improvised scale
|
||
|
||
PROCEDURE:
|
||
|
||
1. Weigh out 2 grams (or equal amounts) by weight of picric acid and lead
|
||
monoxide.
|
||
|
||
2. Add the picric acid to 2 teaspoons (10 ml) of methanol in a container
|
||
(dish or saucer) and stir.
|
||
|
||
3. Add lead monoxide and stir.
|
||
|
||
4. Continue stirring and allow the alcohol to evaporate. NOTE: The mixture
|
||
will suddenly thicken.
|
||
|
||
5. Carefully break up this mixture and stir occassionally until a powder is
|
||
formed (a few lumps will remain).
|
||
|
||
6. Remove and spread out to air dry. NOTE: if possible, dry at 100 degrees
|
||
C (212 F) for two hours.
|
||
|
||
* * *
|
||
|
||
PREPARATION OF PICRIC ACID FROM ASPIRIN
|
||
|
||
Picric acid can be used as a booster explosive in detonators or as an
|
||
intermediate to preparing lead picrate or DDNP.
|
||
|
||
MATERIAL REQUIRED:
|
||
|
||
- Aspirin, 20 tablets (5 grain/tablet)
|
||
- Alcohol, 95% pure
|
||
- Concentrated sulfuric acid (boil battery acid until white fumes appear)
|
||
- Potassium nitrate (saltpeter)
|
||
- Water
|
||
- Canning jar (1 pint)
|
||
- Hot water bath
|
||
- Paper towels (for filter)
|
||
- Glass tube or rod
|
||
- Glass containers
|
||
- Dish (ceramic or glass)
|
||
- Heat source
|
||
- Cup
|
||
- Teaspoon
|
||
|
||
PROCEDURE:
|
||
|
||
1. Crush 20 tablets of aspirin in a glass container and work into a paste
|
||
with a teaspoon of water.
|
||
|
||
2. Add approximately 1/3 - 1/2 cup (100 ml) of alcohol with stirring and
|
||
filter through a paper towel into another glass container.
|
||
|
||
If aspirin is pure enough (usually cheap priced aspirin are) then Steps 1, 2
|
||
and 3 can be omitted and can proceed and add crushed aspirin to Sulfuric Acid.
|
||
|
||
3. Discard the solid left on the paper and pour the liquid from the container
|
||
into the dish. Evaporate the alcohol and water on a hot water bath, leaving a
|
||
white powder.
|
||
|
||
4. Add this white powder to 1/3 cup (80 ml) of concentrated sulfuric acid in
|
||
a canning jar.
|
||
|
||
5. Heat the jar in a simmering hot water bath for 15 minutes and remove.
|
||
Stir; solution will gradually turn black.
|
||
|
||
6. Add 3 level teaspoons (15 gm) of potassium nitrate in three portions with
|
||
vigorous stirring. After heating put jar in cold water and add potassium
|
||
nitrate.
|
||
|
||
7. Allow the yellow-orange solution to cool to room temperature with
|
||
intermittent stirring. Solution is darker than yellow-orange.
|
||
|
||
8. Pour the solution into 1-1/4 cups (300 ml) of water (cold if possible) and
|
||
allow to cool. Upon pouring, solution is now yellow-orange.
|
||
|
||
9. Filter the mixture through a paper towel and wash the light yellow
|
||
material (picric acid) with 1/8 cup (25 ml) of water through paper towel. Takes
|
||
considerable time to filter if genuine filter paper is used.
|
||
|
||
10. Dry at 160-200 degrees F for two hours. The yield is 4.0-4.5 grams.
|
||
|
||
* * *
|
||
|
||
TETRAMMINECOPPER (II) CHLORATE
|
||
|
||
Tetramminecopper (II) chlorate is a primary explosive that can be made from
|
||
sodium chlorate, copper sulfate, and ammonia.
|
||
|
||
MATERIAL REQUIRED:
|
||
|
||
- Sodium chlorate (obtain as medicine, weed killer, defoliant, or by field
|
||
method)
|
||
- Copper sulfate (obtain as insecticide, water purifying agent, or by field
|
||
method)
|
||
- Ammonium hydroxide (obtain as household ammonia or smelling salts)
|
||
- Alcohol, 95% pure
|
||
- Wax or clay
|
||
- Water
|
||
- Narrow mouth bottle (wine or coke)
|
||
- Wide mouth bottles (mason jars)
|
||
- Tubing (rubber, copper, steel)
|
||
- Teaspoon
|
||
- Improvised scale
|
||
- Heat source
|
||
- Paper towel (for filter)
|
||
- Pan
|
||
|
||
PROCEDURE:
|
||
|
||
1. Measure 1/3 teaspoon (2.5 gm) of sodium chlorate in a wide mouth bottle,
|
||
then add 10 teaspoons of alcohol.
|
||
|
||
2. Add 1 teaspoon (4 gm) of copper sulfate and stir the mixture just under
|
||
the boiling point for 30 minutes (heat can be supplied by a pan of hot water).
|
||
The mixture will change color. NOTE: Keep solution away from flame.
|
||
|
||
3. Keep volume of the solution constant by adding additional alcohol about
|
||
every 10 minutes. Remove solution and let cool. Filter through folded paper
|
||
towels into another wide mouth bottle. Keep the liquid.
|
||
|
||
4. Add 1 cup (250 ml) of ammonia to the narrow mouth bottle. Placing tubing
|
||
that it extends about 1-1/2 inches inside bottle, then seal tubing to bottle
|
||
with wax (pitch, clay, etc.).
|
||
|
||
5. Place tubing into solution from step (3) such that the end of the tubing
|
||
is projected about 3/4 of the way into the solution. If the narrow mouth bottle
|
||
is not taller than the wide mouth bottle, then elevate the narrow mouth bottle
|
||
so than the tubing falls into the flask.
|
||
|
||
|
||
....
|
||
. ..
|
||
. ..
|
||
. .. Tubing
|
||
III ..
|
||
I.I ..
|
||
I.I ..
|
||
I . I ..
|
||
I I ..
|
||
I I ..
|
||
I///////I ..
|
||
Ammonia I///////I I .. I
|
||
I///////I I**..**I Solution
|
||
I///////I I**..**I
|
||
IIIIIIIII I******I
|
||
Heat IIIIIIII
|
||
|
||
6. Bubble ammonia gas through solution until color of the solution changes
|
||
from a light green to a dark blue (approximately 10 minutes) and continue
|
||
bubbling for another ten minutes.
|
||
|
||
CAUTION: At this point the solution is a primary explosive. Keep away from
|
||
flame!
|
||
|
||
7. Reduce the volume of the solution to about 1/3 of its original volume by
|
||
evaporating in the air or in a stream of air.
|
||
|
||
8. Filter crystals through a folded paper towel and wash once with 1 teaspoon
|
||
alcohol, dry overnight (16 hours).
|
||
|
||
CAUTION: Explosive is shock and flame sensitive. Store in a capped
|
||
container.
|
||
|
||
* * *
|
||
|
||
POTASSIUM (OR SODIUM) NITRATE AND LITHARGE (LEAD MONOXIDE)
|
||
|
||
Either of the nitrates are needed to prepare DDNP and litharge is required for
|
||
the preparation of lead picrate.
|
||
|
||
MATERIAL REQUIRED:
|
||
|
||
- Lead metal (small pieces or chips)
|
||
- Potassium (or sodium) nitrate
|
||
- Wood (methyl) alcohol
|
||
- Iron pipe with closed end or cap (one end only)
|
||
- Iron rod (screwdriver)
|
||
- Paper towels
|
||
- Glass jars, wide mouth (2 each)
|
||
- Pan (metal)
|
||
- Heat source (such as hot coals or blow torch)
|
||
- Improvised scale
|
||
- Cup
|
||
|
||
PROCEDURE:
|
||
|
||
1. Mix 12 grams of lead and 4 grams of potassium (or sodium) nitrate. Place
|
||
the mixture in the iron container (iron pipe) and heat in a hot bed of coals or
|
||
by a blow torch for hour or more.
|
||
|
||
2. Remove the container and allow to cool. Chip out the yellow solid with
|
||
the screwdriver and add to 1/2 cup (120 ml) of methyl alcohol in the jar.
|
||
Orange-Brown solid, cream color in alcohol.
|
||
|
||
3. Heat the mixture in a pan of hot water until it reacts. Solution turns
|
||
darker upon heating.
|
||
|
||
4. Filter the mixtrue through a paper towel into the second jar.
|
||
|
||
5. The solid left on the paper is lead monoxide. Wash it through paper
|
||
twice, using 1/2 cup (120 ml) hot water each time and air dry before using in
|
||
explosive preparation (for example, lead picrate).
|
||
|
||
6. Place the jar with the liquid in the hot water and heat until alcohol has
|
||
evaporated. The remaining powder is the nitrite, snowy liquid; some white
|
||
powder appears but not much.
|
||
|
||
NOTE: Sodium nitrite has a strong tendency to absorb water from the
|
||
atmosphere and should be stored in a closed container.
|
||
|
||
* * *
|
||
|
||
PREPARATION OF COPPER SULFATE (PENTAHYDRATE)
|
||
|
||
Copper sulfate is a required material for the preparation of TAC.
|
||
|
||
MATERIAL REQUIRED:
|
||
|
||
- Copper wire or pieces
|
||
- Sulfuric acid (battery)
|
||
- Potassium nitrate or nitric acid (field grades)
|
||
- Alcohol
|
||
- Water
|
||
- Two heat resistant glasses or jars, one pint
|
||
- Paper towels
|
||
- Metal pan (for hot water bath)
|
||
- Wooden rod
|
||
- Improvised scale
|
||
- Cup
|
||
|
||
PROCEDURE:
|
||
|
||
1. Place 10 grams of copper into one of the jars and add one cup (240 ml) of
|
||
sulfuric (battery) acid. To this mixture add 12 grams of potassium nitrate, or
|
||
1-1/2 teaspoons of nitric acid. NOTE: Nitric acid gives a product of greater
|
||
purity.
|
||
|
||
2. Heat the mixture on a hot water bath (near boiling) until the bubbling has
|
||
ceased (requires about two hours).
|
||
|
||
CAUTION: This reaction evolves strong toxic fumes and therefore must be
|
||
performed in an open, well ventilated area.
|
||
|
||
3. Pour the hot blue liquid into a second vessel (keeping the unreacted
|
||
copper in the first jar) and allow to cool at room temperature.
|
||
|
||
4. After the crystals have formed, carefully pour away the liquid and break
|
||
up the crystals. Then add 1/2 cup (120 ml) of alcohol to the powder and stir.
|
||
|
||
5. Pour the solution through the towel filter and wash the solid left on the
|
||
paper three times, using 1/2 cup (120 ml) portions of the alcohol each time.
|
||
|
||
6. Allow the product to air dry for two hours.
|
||
|
||
* * *
|
||
|
||
Brought to you by...
|
||
The Cheshire Cat
|
||
Call The Works BBS - 1600+ Textfiles! - [914]/238-8195 - 300/1200 - Always Open
|
||
|