90 lines
4.9 KiB
Plaintext
90 lines
4.9 KiB
Plaintext
Counterfeiting Money by JRoger
|
||
|
||
Before reading this article, it would be a very good idea to get a
|
||
book on photo offset printing, for this is the method used in
|
||
counterfeiting US currency. If you are familiar with this method
|
||
of printing, counterfeiting should be a simple task for you.
|
||
|
||
Genuine currency is made by a process called "gravure", which
|
||
involves etching a metal block. Since etching a metal block is
|
||
impossible to do by hand, photo offset printing comes into the
|
||
process.
|
||
|
||
Photo offset printing starts by making negatives of the currency
|
||
with a camera, and putting the negatives on a piece of masking
|
||
material (usually orange in color). The stripped negatives,
|
||
commonly called "flats", are then exposed to a lithographic plate
|
||
with an arc light plate maker. The burned plates are then
|
||
developed with the proper developing chemical. One at a time,
|
||
these plates are wrapped around the plate cylinder of the press.
|
||
|
||
The press to use should be an 11 by 14 offset, such as the AB Dick
|
||
360. Make 2 negatives of the portrait side of the bill, and 1 of
|
||
the back side. After developing them and letting them dry, take
|
||
them to a light table. Using opaque on one of the portrait sides,
|
||
touch out all the green, which is the seal and the serial numbers.
|
||
The back side does not require any retouching, because it is all
|
||
one color. Now, make sure all of the negatives are registered
|
||
(lined up correctly) on the flats. By the way, every time you
|
||
need another serial number, shoot 1 negative of the portrait side,
|
||
cut out the serial number, and remove the old serial number from
|
||
the flat replacing it with the new one.
|
||
|
||
Now you have all 3 flats, and each represents a different color:
|
||
black, and 2 shades of green (the two shades of green are created
|
||
by mixing inks). Now you are ready to burn the plates. Take a
|
||
lithographic plate and etch three marks on it. These marks must
|
||
be 2 and 9/16 inches apart, starting on one of the short edges.
|
||
Do the same thing to 2 more plates. Then, take 1 of the flats and
|
||
place it on the plate, exactly lining the short edge up with the
|
||
edge of the plate. Burn it, move it up to the next mark, and
|
||
cover up the exposed area you have already burned. Burn that, and
|
||
do the same thing 2 more times, moving the flat up one more mark.
|
||
Do the same process with the other 2 flats (each on a separate
|
||
plate). Develop all three plates. You should now have 4 images
|
||
on each plate with an equal space between each bill.
|
||
|
||
The paper you will need will not match exactly, but it will do for
|
||
most situations. The paper to use should have a 25% rag content.
|
||
By the way, Disaperf computer paper (invisible perforation) does
|
||
the job well. Take the paper and load it into the press. Be sure
|
||
to set the air, buckle, and paper thickness right. Start with the
|
||
black plate (the plate without the serial numbers). Wrap it
|
||
around the cylinder and load black ink in. Make sure you run more
|
||
than you need because there will be a lot of rejects. Then, while
|
||
that is printing, mix the inks for the serial numbers and the back
|
||
side. You will need to add some white and maybe yellow to the
|
||
serial number ink. You also need to add black to the back side.
|
||
Experiment until you get it right. Now, clean the press and print
|
||
the other side. You will now have a bill with no green seal or
|
||
serial numbers. Print a few with one serial number, make another
|
||
and repeat. Keep doing this until you have as many different
|
||
numbers as you want. Then cut the bills to the exact size with a
|
||
paper cutter. You should have printed a large amount of money by
|
||
now, but there is still one problem; the paper is pure white. To
|
||
dye it, mix the following in a pan: 2 cups of hot water, 4 tea
|
||
bags, and about 16 to 20 drops of green food coloring (experiment
|
||
with this). Dip one of the bills in and compare it to a genuine
|
||
US bill. Make the necessary adjustments, and dye all the bills.
|
||
Also, it is a good idea to make them look used. For example,
|
||
wrinkle them, rub coffee grinds on them, etc.
|
||
|
||
As before mentioned, unless you are familiar with photo offset
|
||
printing, most of the information in this article will be fairly
|
||
hard to understand. Along with getting a book on photo offset
|
||
printing, try to see the movie "To Live and Die in LA". It is
|
||
about a counterfeiter, and the producer does a pretty good job of
|
||
showing how to counterfeit. A good book on the subject is "The
|
||
Poor Man's James Bond".
|
||
|
||
If all of this seems too complicated to you, there is one other
|
||
method available for counterfeiting: The Canon color laser
|
||
copier. The Canon can replicate ANYTHING in vibrant color,
|
||
including US currency. But, once again, the main problem in
|
||
counterfeiting is the paper used. So, experiment, and good luck!
|
||
|
||
-= Exodus =-
|
||
|
||
|
||
|
||
|