1 line
3.4 KiB
Plaintext
1 line
3.4 KiB
Plaintext
|
%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%
%% %%
%% ================ %%
%% SODIUM CHLORATE! %%
%% ================ %%
%% %%
%% Typed by %%
%% --==**>>THE REFLEX<<**==-- %%
%% [Member: Omnipotent, Inc.] %%
%% %%
%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%
Sodium chlorate is a strong oxidizer used in the manufacture of
explosives. It can be used in place of potassium chlorate.
MATERIALS AND THEIR SOURCES
=-=-=-=-=-=-=-=-=-=-=-=-=-=
[1] 2 carbon or lead rods (1 in. diameter X 5 in. long)
- Dry cell batteries (2-1/2 in. diameter X 7 in. long) or plumbing supply
store
[2] Salt or, ocean water
- Grocery store or ocean
[3] Sulfuric acid, diluted
- Motor vehicle batteries
[4] Motor vehicle
[5] Water
[6] 2 wires, 16 gauge (3/64 in. diameter approx.), 6 ft. long, insulated
[7] Gasoline
[8] 1 gallon glass jar, wide mouth (5 in. diameter X 6 in. high approx.)
[9] Sticks
[10] String
[11] Teaspoon
[12] Trays
[13] Trays
[14] Cup
[15] Heavy cloth
[16] Knife
[17] Large flat pan or tray
PROCEDURE
=-=-=-=-=
[1] Mix 1/2 cup of salt into the one gallon glass jar with 3 liters (3 quarts)
of water.
[2] Add 2 teaspoons of battery acid to the solution and stir vigorously for 5
minutes.
[3] Strip about 4 inches of insulation from both ends of the 2 wires.
[4] With knife and sticks shape 2 strips of wood 1 X 1/8 X 1-1/2. Tie the wood
strips to the lead or carbon rods so that they are 1-1/2 inches apart.
--- ---
! ! ! !
! !------! !
! !^wood^! !
! !------! !
! !^wood^! !
--- ---
Tie so the rods are 1-1/2 inches apart.
[5] Connect the rods the battery in a motor vehicle (car) with the insulated
wire.
[6] Submerge 4-1/2 in. of the rods into the salt water solution with the wires
still exposed to the air.
[7] With gear in neutral position, start the vehicle engine. Depress the
accellerator approximately 1/5 of its full travel.
[8] Run the engine with the accelerator in this position for 2 hours; then,
shut it down for 2 hours.
[9] Repeat this cycle for a total of 64 hours while maintaining the level of
the acid-salt water solution in the glass jar.
CAUTION: This arrangement employs voltages which may be dangerous to
~~~~~~~~ personnel. Do not touch bare wire leads while engine is running.
[10] Shut off the engine. Remove the rods from the glass jar and disconnect
wire leads from the battery.
[11] Filter the solution through the heavy cloth into a flat pan or tray,
leaving the sediment at the bottom of the glass jar.
[12] Allow the water in the filtered solution to evaporate at room temperature
(approx. 16 hours). The residue is approximately 60% or more sodium
chlorate which is pure enough to be used as an explosive ingredient.
---------------------------------------
|